DBI SALA Anchor on the Go Installations- und Betriebsanleitung - Seite 12
Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Industrielle Ausrüstung DBI SALA Anchor on the Go herunter. DBI SALA Anchor on the Go 20 Seiten. Portable roof anchor for metal roofs
Seite druckenslid up the rope as much as an arm's
Figure Six
length. It should immediately be
released to lock the rope grab onto
the rope. The worker should climb
towards the rope grab and repeat the
movement until the work position has
been reached.
When moving down the roof, the
worker should move down until the
rope is taught, then release and
move the rope grab towards the
body, releasing it to again provide an
anchor. When the work position has
been reached, the rope grab should be
released and run up the rope toward
the roof ridge to remove as much
slack as possible.
By removing the working slack from the system, the person reduces the
risk of swing fall, lessens overall fall distance and reduces possible fall
distance in the event the roof surface gives way, allowing the person to
fall through.
GENERAL OPERATIONAL WARNINGS – SAFE WORK AREA
When traversing the roof, the same procedure should be followed
and should be set up such that the system operator will be
prevented from reaching an unprotected edge.
The operator of the Anchor on the Go™ Portable Roof Anchor
shall be trained and ensure that care is taken to adjust the safety
line length so that he/she will not be able to fall off the ends of
the roof.
The maximum number of operators connected at a time shall not
exceed one.
Do not climb onto the same side of roof that the anchor is installed
on. If work is required on both sides of the roof, install two
separate Anchor on the Go™ anchors and rope lines on opposite
sides.
12