DBI SALA Sayfline 7603000 Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Schutzvorrichtung DBI SALA Sayfline 7603000 herunter. DBI SALA Sayfline 7603000 17 Seiten.

Seite drucken

sleeve(s) onto the lifeline before terminating the other

end of the cable to the anchor.

Step 4.

If additional intermediate brackets are purchased,

slide all of the cable guides from the brackets onto

the cable before installing the cable.

Step 5.

The intermediate brackets are composed of three

parts: two side plates and a cable guide. Each of the

plates is stamped with the letter "A" or "B". See

Figure 10. To assemble a bracket, start by placing a

cable guide into Part A at the appropriate angle as

determined in Step 2. Then slide Part B onto the

cable guide at the same angle and nestle Part B

into Part A. Place the assembled bracket at its

designated anchor point and anchor it by placing

the user supplied bolt through a flat washer and

then though the mated holes in the bracket and

into the anchor point. The bolt may be installed

through the anchor and into the bracket if

preferred, but the washer must remain inside the

bracket, between the bracket and the bolt head

or nut. Torque the anchor hardware to 55 ft./lbs.

Step 6.

Before terminating the second end of the

horizontal lifeline, unthread the turnbuckle on the

first end so that only four threads are visible

inside the turnbuckle body. This will allow for

maximum tensioning of the system after

anchoring the second end. Install all of the

Sayflink sleeves onto the cable before terminating the second end.

Step 7.

To terminate the second end of the cable to its anchor, attach the shackles to the anchor and Zorbit as

described in Step 3. Then attach the thimble and connecting hardware to the Zorbit. See Figure 11.

Slide the lifeline through the thimble. Remove excess slack by pulling the wire rope through the thimble

and cable clip. Maintain tension while torquing the cable clip nut and the thimble clip nut to the values

specified in Figure 11. Tension the wire rope by turning the turnbuckle at the other end of the installation.

The unrestrained turnbuckle jaw end must be prevented from turning to prevent twisting the wire rope.

The wire rope must be tensioned until the sag on the system at mid-span, between intermediate

brackets, is two inches or less, with no weight on the wire rope.

Sayfline Wire Rope HLL System End Termination

Cable Clip

Torque to 45 ft/lbs

Figure 11 - Thimble/Cable Clip End Termination

Figure 9 - Cable Termination

Figure 10 - Bracket Assembly

Part A

Part B

Cable Guide

Thimble/Cable Clip

Torque to 40 ft/lbs

Shackles

Zorbit Shock

Absorber

Turnbuckle