Galanz P100D48AL-JC Gebrauchsanweisung für den Besitzer - Seite 19
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für den Besitzer für Mikrowellenherd Galanz P100D48AL-JC herunter. Galanz P100D48AL-JC 20 Seiten.
Seite druckenwithout the filters in place.
1. Pull down slightly on the tab toward the
front of the oven and remove the filter.
Repeat for the other filter.
2. Soak the filter in a sink or dish pan filled
with hot water and detergent. DO NOT
use ammonia or other alkali; they will
react with the filter material and darken it.
3. Agitate and scrub with a brush to remove
embedded dirt.
4. Rinse thoroughly and shake dry.
5. Replace by fitting the filter back into the
opening.
Light
1. To replace light bulbs, first disconnect
power to the oven at the circuit breaker
panel or by unplugging.
2. To release cover, remove the screw on
the light cover. (See illustration.)
3. DO NOT USE A BULB LARGER THAN
30 WATTS.
4. Close light cover and secure with screw
removed in step 2.
CAUTION: Light cover may become very
hot. Do not touch glass when light is on.
Charcoal Filter
Charcoal filter is used for nonvented,
recirculated installation. The filter should be
changed every 6 to 12 months depending
on use.
1. Disconnect power to the oven at the
circuit breaker panel or by unplugging.
2. Remove the louver mounting screw from
the top center of the louver and push
down carefully on the tab at each end of
the
louver
illustration.)
3. Pull the louver away from the unit.
4. Change the charcoal filter.
5. Carefully push the louver back into place
and replace the screw remove in step 2.
Oven Light
Remove the louver per instructions 1~3
above and charcoal filter, if used.
1. Open light cover located behind filter
mounting by carefully pulling up on the
front edge.
2. DO NOT USE A BULB LARGER THAN
30 WATTS.
3. Replace the oven light cover by carefully
pushing into place. Replace the charcoal
18
to
disengage
it.
(See