Galanz DUK001W Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Trockner Galanz DUK001W herunter. Galanz DUK001W 12 Seiten.

Seite drucken

Positioning

It is recommended that, for your convenience, the machine is positioned close to your washing

machine. Whilst drying, the tumble dryer will expel a certain amount of warm, very moist air and this

should be removed from the room as quickly as possible to prevent condensation. In an extremely

well-ventilated room or close to an open window, this may occur naturally. However, in general, it is

better to carry the dryer's exhaust outside via the vent hose supplied with the appliance; ending

either temporarily at an open window, or permanently at a fixed ventilation grille, fitted to an exterior

wall or window.

The tumble dryer must be installed in a clean place, where dirt does not build up. Make sure there

are no obstructing items or material near the air-intake louvres provided at the back (e.g. paper, rags

etc). To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm,

level surface.

If the floor is uneven, adjust the adjustable feet. Do not put

any wooden pieces or other objects under the feet or base.

When pressure is applied to the edge of the machine it

should not shake (please check in two directions).If shaking

is present re-adjust the adjustable feet.

IMPORTANT:

The hot air emitted by the tumble dryer can reach

temperatures of up to 60°C.The appliance must therefore

not be installed on floors which are not resistant to high temperatures.

Removing Transport Safety Packaging Foam

Caution!

Before using the machine, the packaging foam must be removed from the drum.

1. Open the loading door.

2. Pull off adhesive strips on top of drum from inside machine.

3. Remove the two packaging foams from inside machine.

Fitting The Vent Hose

To simplify the installation, there is a choice of vent outlets: one at the back, the other in the left hand

side. Connect the hose to whichever is the more convenient by pulling the ring nut (A)from the vent

outlet at the back, aligning arrows of hose and ring nut, fastening by screwing hose to the direction

of arrow and pushing it firmly back into place. The unused vents should now be sealed with the

special snap cover (B) provided.

If the hose is long and the room temperature low, the moisture might condense

inside the hose. This is an unavoidable natural phenomenon. To prevent this

water from lying in the hose or flowing back into the tumble dryer, it is advisable

to drill a small hole (dia.3 mm) in the lowest point of the hose and to place a

small container below it. (See picture, point B). Once connected to the dryer,

run the vent hose to the desired outlet point, ensuring it contains no more than

two bends. As to the outlet itself, if you have decided on a fixed wall/window

grille, a good local builder's merchant should be able to supply you with the

necessary fittings and installation advice.

It is important not to connect the vent hose to, for example, a cooker hood, or a chimney or flue

pipe designed to carry the exhaust from a fuel burning appliance.

Note that to avoid condensation problems, it is essential that the dryer is fitted with the flexible

hose to carry hot air outside the kitchen. In order to prevent the appliance from overheating, it is

important that the steam exhaust is unobstructed. If the dryer is fitted next to kitchen units, make

sure that the vent hose is not squashed. If the hose is partially squashed, drying efficiency will be

reduced, resulting in longer drying times and higher energy consumption. If the hose is completely

squashed, the safety cut-outs with which the machine is fitted may operate.