dBTechnologies DVA MINI G2 Schnellstart-Benutzerhandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Schnellstart-Benutzerhandbuch für Lautsprechersystem dBTechnologies DVA MINI G2 herunter. dBTechnologies DVA MINI G2 7 Seiten.
Seite drucken
DVA MINI G2
www.dbtechnologies.com
IV) First switch on for line-array setup
The DIGIPRO
controlled by a powerful DSP. All the connections and
controls are in the rear amplifier control panel:
1 – Balanced audio input and output link
2 – DSP preset rotary switch
3 – RDNet Data In / Data out
4 – USB port for firmware updating
5 – Status LEDs (Limiter, Signal, Status, ON)
6 – Auto-range Mains Input
7 – Mains link output
8 – Mains fuse
WARNING
The fuse is factory set for
If it is necessary to change the fuse to
1.
Turn off the power and disconnect the speaker from
any cable.
2.
Wait 5 minutes.
3.
Substitute the fuse with the correct one supplied.
a)
Once you have properly set up the mechanical
line-array configuration (see also the DVA MINI G2
complete user manual and accessories instructions for
further information), connect the audio input (1) of the
first module of the array. Then connect the useful link
audio output (1) to other DVA MINI G2 modules, for
the connection of all the line-array elements.
b)
The configuration can be set and modified by
the user of the local DSP Preset (2) rotary or remote
controlled (RDNet Control 2 or RDNet Control 8) using
softwares (dBTechnologies AURORA NET). For further
information see the chapter 5.
The DSP preset is divided into 3 main operation areas:
1) FRONT FILL usage
2) up to 6 boxes (HF1/HF2/HF3)
3) more than 6 boxes (HF1/HF2/HF3)
HF1 – short distance coverage setup
HF2 – medium distance coverage setup
HF3 – far distance coverage setup
c)
Connect the power link output (7) of the first
module to the mains input (6) of a second DVA MINI
G2 module of the line-array, and so on, in order to
link the power supply between all the elements. The
maximum linkable rated power and current depends
on the first module connection (type of cable, type of
connector used). The plate data give information
about the entire linked line-array system. The
maximum number of modules for each power daisy
chain connection [mains input + mains link] is: 1+9
DVA MINI G2s** at 220-240V~, and 1+7 DVA MINI
G2s** at 100-120V~ (for further information see
Technical Data).
5
info@dbtechnologies‐aeb.com
G3®
amplifier of DVA MINI G2 is
220-240V~
operation.
100-120V~
Rev 1.0 cod. 420120326Q
range: