909 DH1500 Gebrauchsanweisung - Seite 6
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug 909 DH1500 herunter. 909 DH1500 10 Seiten. 1500w demolition breaker
Seite druckento these chemicals; work in a well ventilated area, and
work with approved safety equipment, such as those dust
masks that are specifically designed to filter out microscopic
particles. Always wear eye protection and a dust mask
for dusty applications. Sanding particles can be absorbed
by your eyes and inhaled easily and may cause health
complications.
•
Wear ear protectors. Exposure to noise can cause
hearing loss.
•
Use auxiliary handle(s), if supplied with the tool. Loss of
control can cause personal injury.
•
Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord. Cutting accessory
contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an
electric shock.
•
Wear a hard hat (safety helmet), safety glasses and/or
face shield. Ordinary eye or sun glasses are NOT safety
glasses. It is also highly recommended that you wear a
dust mask and thickly padded gloves.
•
Be sure the bit is secured in place before operation.
•
Under normal operation, the tool is designed to produce
vibration. The screws can come loose easily, causing
a breakdown or accident. Check tightness of screws
carefully before operation.
•
In cold weather or when the tool has not been used for a
long time, let the tool warm up for a while by operating it
under no load. This will loosen up the lubrication. Without
proper warm-up, hammering operation is difficult.
•
Always be sure you have a firm footing. Be sure no one
is below when using the tool in high locations.
•
Hold the tool firmly with both hands.
•
Keep hands away from moving parts.
•
Do not leave the tool running. Operate the tool only when
hand-held.
•
Do not point the tool at any one in the area when
operating. The bit could fly out and injure someone
seriously.
•
Do not touch the bit or parts close to the bit immediately
after operation; they may be extremely hot and could
burn your skin.
•
Do not operate the tool at no-load unnecessarily.
•
Some material contains chemicals which may be toxic.
Take caution to prevent dust inhalation and skin contact.
WARNING.
We recommend the use of a residual current
device with a residual current rating of 30mA or less.
Wear goggles
Wear ear muffs
Wear a breathing mask
Contents of carton
The Demolition Breaker is supplied with the following
accessories:
•
Auxiliary handle
•
Chisel bits:
Point chisel hex 30mm x 350mm
Flat chisel hex 30mm x 350mm
•
Allen key
•
Grease pot
6