Galaxy DX 93T Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sende- und Empfangsgerät Galaxy DX 93T herunter. Galaxy DX 93T 11 Seiten. 10 meter amateur mobile transceiver with built-in frequency counter & starlite face plate

Seite drucken

1. Front Panel

IGNITION NOISE INTERFERENCE

With weak signals, you may experience interference of the signal by

background noise. This radio has NB and ANL circuits which will help reduce

background noise from sources such as your ignition system. However,

background electrical noise may come from several sources and all noise may not

be eliminated. With extremely weak signals, you can operate this radio with the

engine turned off, which should improve reception. If the ignition noise level is

too high to allow proper operation under most conditions, you should have your

installation of the radio checked by a qualified technician.

ANTENNA

This radio has a jack in the rear for a standard PL-259 antenna plug. If you are

looking for the most range for your transmission, use a vertically polarized,

quarter-wave length antenna. If antenna height is a problem, you may use a

shorter, loaded-type whip antenna although you can expect some loss of

transmission range.

To improve performance, your antenna should be matched to your radio. Your

antenna can be adjusted so that it matches your radio.

EXTERNAL SPEAKER

The external speaker jack (EXT SP.) on the rear panel is used for remote

receiver monitoring. The external speaker should have 8 ohms impedance and be

able to handle at least 4 watts. When the external speaker is plugged in, the

internal speaker is disconnected.

PUBLIC ADDRESS

To use the Public Address (PA) function, first connect an external speaker to

the PA. SP. Jack on the rear of the radio. See the above specifications for a proper

external speaker. Keep the speaker away from the microphone to avoid acoustic

feedback.

- 4 -

CHAPTER 3 OPERATION

CONTROL FUNCTIONS

FRONT PANEL

15 16

17 18

T w i n T u r b i n e

M OD

M O D

M ED

PW R

SW R

PW R

VO L

DX 93T

O FF

1. MOD LAMP: When switched on, this Modulation indicator will illuminate

as you speak into the microphone. When you speak louder, it appears bright

because it is on nearly 100 percent of the time and when you speak softer, it

appears dimmer because it is flickering on and off. It does not glow at all

when there is no modulation. This lamp operates in all modes.

2. SWR/MOD/PWR SWITCH: This switch controls the function of the meter

during the transmit mode. In the "SWR" position, the meter indicates the

Standing Wave Ratio (SWR) of your antenna (accurate only in HI power).

There are no adjustments because the SWR circuit in this radio calibrates

itself automatically. When the switch is in the "MOD" position, the green

scale on the meter indicates your percentage of modulation in the AM mode

only. It is most accurate when testing at maximum power output. When this

switch is in "PWR" position, the meter indicates your power output.

3. MICROPHONE JACK: Used to connect microphone.

4. ON/OFF VOLUME CONTROL: This knob controls the volume and power

to the radio. To turn radio on, rotate the knob clockwise. Turning the knob

further will increase the volume of the receiver.

U SB

LSB

H I G H SW R ALERT

5/ 6 D I G I T

M O D

O FF

H I

LAM P

+10KH z

A N L

40dB

D I M

RX/ TX

PAD

M I C

EC HO

TI M E

FI N E

C O ARSE

PUSH

TB O FF

O FF

N B/ AN L

- 5 -

N B

+10

PAD

KH z