dbx iEQ-15 Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Stereo-Entzerrer dbx iEQ-15 herunter. dbx iEQ-15 16 Seiten. Graphic eq
Auch für dbx iEQ-15: Spezifikationen (2 seiten), Benutzerhandbuch (20 seiten), Schnelle Übersicht (4 seiten)

Seite drucken

iEQ

iEQ31 - dual channel 31 band graphic equalizer

Input Gain Control: This control sets the signal level to the equalizer. It is capable of -12dB

to +12dB of gain. Its effect is apparent by viewing the OUTPUT LEVEL BAR GRAPH.

EQ Bypass: This switch removes the graphic equalizer section from the signal path. The

BYPASS switch does not, however, affect the INPUT GAIN, AFS, or LOW CUT filters. This but-

ton lights red when the EQ is in bypass mode

Boost/Cut Range Selection Switch: This switch selects which of the two boost/cut ranges the

equalizer will use, either ±6dB or ±15dB. The button lights red when the ±15dB range is select-

ed.

Output Level Bar Graph: These four LEDs indicate output level of the equalizer. It monitors

the level at the output of the equalizer after all other processing, including the limiter.

Clip LED: This LED lights whenever any internal signal level reaches 1dB below clipping which

may occur when any of the following happen: 1) the input signal is "hotter" than +20dBu, 2)

excessive gain is applied by the input gain control, or 3) excessive boost is applied using the

frequency sliders.

Gain Reduction Meter: These four LEDs indicate the amount of gain reduction being induced

by the setting of the PeakStopPlus

graphic EQ section exceeds this limiter threshold setting.

PeakStopPlus

Limiter Threshold Control: This control engages the PeakStopPlus™ limiter.

It sets the threshold level at which ∞:1 gain reduction will begin to occur. It is capable of a

range of 0dBu through "OFF" (+20dBu). When the threshold control is set to "OFF", the limiter

is effectively disabled, and no gain reduction will occur.

AFS™ (Advanced Feedback Suppression) Switch: This control engages the AFS function of

the iEQ 15 and 31 If AFS is Off, the filters are bypassed, and the algorithm is halted (the filters

are not updated). If AFS is On, the filters are activeThe AFS modes are as follows:

AFS Mode:

AFS Button LED Color:

Off

Music Low

Green

Music Medium

Yellow

Music High

Lift times are set up at power-up:

Off

Short

10 Minutes

Long

60 Minutes

LIMITER THRESHOLD control as the signal level from the

Off

Red

Front Panel Connections

Bandwidth:

1/10 Octave

1/20 Octave

1/80 Octave

Operation

14.5

116

iEQ User Manual