Galaxy 790.6071 Series Handbuch für Gebrauch und Pflege - Seite 13

Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Pflege für Ranges Galaxy 790.6071 Series herunter. Galaxy 790.6071 Series 16 Seiten.

Fig. 1

use

a Nail

Fig. 2

about 45

Oven Door

Hinge

General Care & Cleaning

Removing

and Replacing

the Oven Door

The door is heavy. For safe, temporary storage, lay the doorflat with

the inside of the door facing down.

To Remove Oven Door:

Open oven door completely (horizontal with floor- See Fig. 1).

Remove 2 screws located on the inside of the oven door liner (See A Fig. 2)

Insert the 2 screws into the door hinge holes located on the side of the

hinge arm, one into each hinge (See B Fig. 2).

Close oven door until the door stops (Do not force the door to close any

further). The placement of these screws should keep door open in about a

45 degree position.

Grasp oven door firmly on both sides and slide door up and off hinges at the

same angle. (See Fig. 3)

To clean oven door, follow the instructions in the Care & Cleaning

table

(page 11).

To Replace Oven Door:

Be sure the hinge arms remain at the 45 degree angle position. Be sure the

screws are still locking the hinge arms from moving. If the screws fall out of

the hinge holes, the hinge(s) may snap back against the oven frame and

could pinch fingers or chip the porcelain finish on the oven front frame.

Hold door at the sides near the top while resting the lower front of door on

your knee. Insert the door channels at the bottom of door over the door

hinges, (See Fig. 3).

Allow the door to slide down into the door hinges evenly at the same 45

degree angle. The hinge arms should be inserted into the bottom corners

as far as they can go.

Open door completely (horizontal with floor) and remove both screws from

holes in door hinges.

Reinstall the 2 screws into the door liner (See C Fig. 2).

If the door is not in alignment with the oven frame, remove door and repeat

the above steps.

iii ............