909 PS26W Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Säge 909 PS26W herunter. 909 PS26W 20 Seiten. 26cc pole trimming saw

Seite drucken

Assembly

This product is partially assembled.

Prior to use, it is necessary to assemble/fit the upper shaft (9),

lower shaft (10), J handle (7), chain (17) and chain bar (12).

Fitting the chain and chain bar

1. Remove the chain drive cover nut (20) with the spanner

supplied (29) and remove the chain drive cover (27).

2. Place the bar on the guide

rail and hold the bar firmly

against the sprocket. Adjust

the chain tension by turning

the chain tensioner screw

(19) so the chain tension

locates in the hole in the bar.

Then remove the bar.

3. Place the chain (17) onto

the outside of the chain bar,

with the chain links in the

direction shown in Pic 3,

ensuring that the teeth are as

shown on the lower side of

the bar when fitted.

4. With the chain fitted to the

bar, hold the bar on an angle

and loop the chain around

the chain drive sprocket until the chain

has fully engaged the sprocket.

When the chain has fully engaged in

the sprocket, lower the bar onto the guide rail.

5. With the chain now secure on

the chain bar and sprocket,

replace the chain drive

cover, and using the spanner

supplied, tighten the nut lightly

to secure the cover back on.

6. Tighten the chain tensioner

screw (19) using the

combination screwdriver

(supplied), by turning the chain tension screw in a

clockwise direction until firm and secure. Then tighten the

chain cover nut firmly using the spanner (supplied) to fully

secure the chain cover.

Note.

Check that the chain can be smoothly pulled around

the guide bar by hand and that it maintains contact with the

guide bar, top and bottom. Do not over tighten, the chain

should be able to lift 4 mm from the middle of the bar.

CAUTIoN.

A new chain will

stretch after just a few minutes

of use. Check and, if necessary,

re-adjust the chain tension. A

loose chain causes rapid wear to

both the chain and the guide bar

and could derail causing a major

safety hazard.

To tighten the chain, loosen the

chain cover nut and rotate the

chain tension screw in a clockwise direction.

To loosen the chain, loosen the chain cover nut and rotate

the chain tensioner screw in an anti-clockwise direction.

Note:

After adjustment, tighten the chain cover nut firmly

with the spanner provided.