909 HD1050 Gebrauchsanweisung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Bohrer 909 HD1050 herunter. 909 HD1050 13 Seiten. 909 hd1050; hd850 high performance hammer action drill

Seite drucken

Auxiliary handle and depth gauge

1. Turn the auxiliary handle (2) anti-clockwise to loosen the

collar and slip it over the chuck onto the drill.

2. Insert the depth gauge (3) in the hole at the

top of the handle (2).

3. The auxiliary handle (2) can swivel 360° for the

most comfortable position and easiest operation.

4. The depth gauge (3) helps keep

an accurate depth when drilling

holes to a set depth.

5. To change the position of the

depth gauge (3), turn the handle

(2) grip anti-clockwise until the

depth gauge is loose enough to

slide through the hole.

6. Set the depth, checking the

depth with a steel rule for most

accurate measurement and then

turn the handle grip clockwise

to tighten both the depth stop

and the auxiliary handle in the

required position.

Inserting and removing bits

CAUTION.

Always ensure that the drill is switched off

and the plug is removed from the power point before

making any adjustments.

This drill has a keyless chuck, which means that a chuck

key is not needed to secure a bit in the drill.

1. Open the chuck by holding the

rear section of the chuck firm

and rotating the front section

in a anti-clockwise direction,

sufficiently enough to allow the

drill bit required to fully enter

the jaws of the chuck.

2. Ensure the drill bit is

fully inserted.

3. Holding the rear section of the

chuck firmly, rotate the front

section of the chuck clock wise

until the jaws tighten on the

drill bit. The front section of the

chuck needs to be tightened

firmly to ensure the drill bit is

held securely.

4. To remove the drill bit, hold the

rear section of the chuck firmly

and rotate sharply the front

section of the chuck in a anti-

clockwise direction, sufficiently

enough to allow the drill bit to

be removed.