909 RH600HT Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Trimmer 909 RH600HT herunter. 909 RH600HT 12 Seiten. 600w 660mm hedge trimmer with rotating handle

Seite drucken

Cutting

1. Assume a secure position, using two hands to hold the

trimmer and switch on.

2. Trim both sides of the hedge, starting at the bottom.

Once you trim the top of the hedge, it is suggested that

you install the cuttings collector to prevent cuttings from

falling into the hedge.

3. Pass the blade lightly through the surface of the hedge.

Do not attempt to cut too deep.

4. Trim the top of the hedge.

5. For older hedges that require

cutting back substantially,

use pruning shears to cut the

thicker branches and then

finish the job with the hedge

trimmer.

WARNING.

Do not let the blade

come into contact with fencing

wire or any other object that

could damage it.

Pruning

Your hedge trimmer is versatile.

It can also be used for trimming

back new growth from small

shrubs onto the driveway or into

the garden.

For optimum trimming

performance, guide the blade

teeth at an angle of approx.

15° to the hedge.

To achieve a hedge with a uniform height it is recommended

that you stretch a piece of string along the edge of the

hedge for guidance. Then simply cut away all twigs

projecting above the line.

Maintenance

Lubrication

WARNING.

Always ensure that

the trimmer is switched off and

the plug is removed from the

power point before making any

adjustments.

After each use, clean the blades

and lightly lubricate with general

purpose oil or spray lubricant

(not included).

1. Remove any deposits with a brush and apply

a light film of oil.

2. Use biodegradable oil.

Maintaining the blades

WARNING.

Always ensure that the trimmer is switched

off and the plug is removed from the power point before

making any adjustments.

IMPORTANT.

Wear sturdy protective gloves at all times.

•

Periodically check blades for sharpness or damage.

•

Oil the blades after

each use using a general spray lubricant.

•

If there is significant blade damage, have them replaced.