909 EDG4 Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Rasenmäher 909 EDG4 herunter. 909 EDG4 13 Seiten. 1200w lawn edger

Edge Guide

The edge guide is used when edging is required against a

solid material like a paved surface. It is important to ensure

the edge guide is used in these conditions as the edge

guide will assist in preventing the blade from making direct

contact with the paved surface.

• To set the edge guide in the Down position, grasp

the Edge Guide Lever (5) and move the knob

sideways toward the centre of the edger and then

push downwards.

Note:

The Edge Guide Lever should be returned to the

upright position to lock the Guide in the down position.

• To set the edge guide in the Up position, grasp the

Edge Guide Lever and move the knob sideways

toward the centre of the edger and then pull upwards

to lift the guide.

Note.

The Edge Guide Lever should be returned to the

upright position to lock the Guide in the raised

Cutting Depth

The cutting depth of the edger can be altered to one of

3 settings to a Max of approx 38mm.

1. To adjust the cutting depth, loosen the height adjustment

knob (9) approx 5–6 full turns, but do not remove. Push

the knob fully towards the body of the edger and at the

same time move the guide wheel arm across to the

opposite side of the housing.

2. Raise or lower the arm to the

desired position, and then

pull the height adjusting knob

outwards. Tighten the knob

until all of the slack is taken

out of the assembly. Check to

ensure the guide wheel arm

has located into one of the pre

allocated positions and the

head of the bolt securing the

position.

front wheel arm is sitting flat on

the surface of the wheel arm.

Firmly tighten the height

adjustment knob.