Hifonics Atlas AX2400D Handbuch für den Besitzer - Seite 12
Blättern Sie online oder laden Sie pdf Handbuch für den Besitzer für Car Stereo System Hifonics Atlas AX2400D herunter. Hifonics Atlas AX2400D 16 Seiten. Atlas series
Seite drucken
AX 1600D / AX 2400D / AX 3200D / AX 4000D
Interconnect cable checklist:
• Connect the LINE INPUT of the amplifier to the head unit line output with good quality RCA to RCA cables.
• Connect the speakers with the terminal block (SPEAKER OUTPUT/ - LEFT + and - RIGHT +) of the amplifier.
•The minimum final speaker impedance must not be below 2 Ohm per channel. Too low speaker loads result in too high
heat dissipation and may cause the amplifier run into protection.
• Please observe speaker channel and polarity as printed by the speaker terminal block.Incorrect phasing of the speakers
results in total loss of bass response.
Be careful not to connect speaker (-) to the ground or vehicle chassis.
INPUT LEVEL
• Turn the INPUT LEVEL control on the amplifier to 5V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL control clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.
Low pass
• This eliminates the higher frequencies.Set the crossover-frequency between 50Hz-100Hz,
depending of the size of the installed speakers.
Subsonic
• This eliminates the lowest frequencies and protects the speakers from damage.
Bass EQ
• Allows you to adjust the bass boost from 0dB up to 18dB
Caution! Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.
Phase
• This allows you to match the Phase 0° to 180°. So you can integrate each subwoofer
Connect RCA cable from
head-unit with RCA input
(LINE INPUT).
Connection for
Remote control
HIFONICS
HIFONICS
POWER
PROTECT
0dB
18dB
12
Amplifier - Applications
Caution!
If you use more than one
subwoofer you can optionaly
use Channel two
Minimum impendance
not under 1 Ohm