909 CSS9 Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Sander 909 CSS9 herunter. 909 CSS9 11 Seiten. 160w

Seite drucken

Dust extraction

WARNING.

Always ensure

that the tool is switched

off and the plug is removed

from the power point before

making any adjustments or

maintenance procedures.

1. Attach the dust canister (4)

to the dust extraction port

of the sander by depressing

the side clips.

WARNING.

For optimum dust

extraction, remove and empty

the canister (4) when it is no

more than half full.

2. Remove the canister by

depressing the side clips

and gently easing the

canister off. To empty the

dust canister gently tap the

canister upside down over a

bin.

If the canister needs a good

clean, there are two screws

that hold the dust bag in the

canister. Unscrew the two

screws and remove the bag.

and give a good clean.

Locate the bag back in the canister and replace the

screws.

3. The dust extraction adaptor

piece (5) can be fitted into the

dust extraction port in place of

the dust canister (4).

4. The sander can then be

connected to a household

vacuum cleaner or

workshop dust extraction

system.

The Detail sander has a rotating platen.

1. Switch off and unplug the

unit.

2. Whilst holding the hand grip

(2) and the platen (3) rotate

to the desired position.

CAUTION.

Where possible,

clamp smaller workpieces to

the bench.

Note.

If there are still scratches

on your work after sanding, try

either of the following:

1. Go back to a coarser grit and

sand the marks out before

recommencing with the

original choice or,

2. Try using new sandpaper

of the same grit to eliminate

the unwanted marks before

progressing to a finer grit

and finishing the job.