DC 1000.4 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken DC 1000.4 herunter. DC 1000.4 8 Seiten.

4-2. 4channels control

RCA JACK INPUT

Low Level Rca Input will accept the signal from the output of

head units. Plug in Rca jack cables from the head unit.

GAIN CONTROL ( 6V ~ 0.2V )

The gain control adjusts the gain level. so that this is used to

match the signal level of di erent headunits.

4-3. Power, Ground & Remote connection.

+12V SOURCE

GND ( GROUND )

Locate a secure grounding connection as close to ampli er as possible.

Make sure the location is clean and provides a direct electrical connection to the frame of the vehicle.

The ground needs to have as low of a resistance as possible.

Connect one end of a short piece of the same size cable as the power cable to the grounding point or to one

of your ba eries or ba ery bank.

Run the other end of 4 ( 0 ) gauge cable to the mounting location of the ampli ers for connection

to the ampli ers ground terminals and connect the ground cable to the GND ( ground terminal ).

Remote Turn on

Working Ba ery voltage

9V to 16volts

HIGH PASS FILTER ( 50Hz ~ 500Hz )

Linkwitz-Riley high pass crossover ensuring that only

the highest frequencies are reproduced by the ampli er

LOW PASS FILTER ( 50Hz ~ 500Hz )

Linkwitz-Riley low pass crossover ensuring that only

the lowest frequencies are reproduced by the ampli er.

X-OVER SLECTOR SWITCH ( HPF/FULL/LPF )

Selected x-over is in e ective.

Fuse

BATTERY

FUSE RATES ;

1100.1 : 100A

2100.1 : 200A

300.4 : 30A

1000.4 : 90A