Autonics ARD-DI16P Handbuch - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für E/A-Systeme Autonics ARD-DI16P herunter. Autonics ARD-DI16P 8 Seiten. Devicenet digital remote i/o
Auch für Autonics ARD-DI16P: Handbuch (8 seiten)
Dimensions
Sensor connector type
● Mounting on DIN rail
31
26
Status LED
Item
Module status (MS)
LED
Network status (NS)
LED
Setup And Installation
Node address setup
● Two rotary switches are used for setting node address.
X10 switch represents the 10's multiplier and X10 switch represents the 1's multiplier.
Node address is settable from 0 to 63.
● Node address is changed when re-supplying the power to the unit.
After changing node address, must re-supply the power.
Mounting on panel
① Pull Rail Locks (standard terminal block type: 3EA, sensor connector type: 2EA)
on the rear part of a unit, there are fixing screw hole.
② Place the unit on a panel to be mounted.
③ Make holes on fixing screw positions.
④ Fasten the screw to fix the unit tightly.
Tightening torque should be below 0.5N·m.
DeviceNet Digital Remote I/O
● Mounting with screws
12
2-Ø4.5
35.3
85.4
LED status
Description
Red
Green
●
Unrecoverable error
●
Recoverable error & communication error of expansion unit
●
Normal operation
●
●
Power is not supplied
●
Normal standby
●
Network On-Line
●
Duplicate, MAC ID / Bus-Off
●
Time Out
●
●
Network Off-Line
● Connector
9.8
※ Tightening torque: 1.8 to 2.5N·m
※ Same dimensions are applied to
both basic and expansion unit.
(
: ON,
: Flash,
: OFF)
(Ex)
X10
(A)
Photoelectric
Sensors
(unit: mm)
(B)
Fiber
Optic
Sensors
(C)
Door/Area
Sensors
(D)
Proximity
Sensors
(E)
Pressure
Sensors
(F)
Rotary
Encoders
(G)
Connectors/
Sockets
(H)
Temperature
Controllers
(I)
SSRs / Power
Controllers
(J)
Counters
(K)
Timers
(L)
Panel
Meters
(M)
Tacho /
Speed / Pulse
Meters
(N)
Display
Units
(O)
Sensor
Controllers
(P)
Switching
Mode Power
Supplies
(Q)
Stepper Motors
& Drivers
& Controllers
(R)
Graphic/
Logic
Panels
(S)
Field
Network
Devices
X1
(T)
Software
S-11