High Energy Sports Quantum Series Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch für Flugzeuge High Energy Sports Quantum Series herunter. High Energy Sports Quantum Series 9 Seiten. Paraglider parachute
Auch für High Energy Sports Quantum Series: Handbuch (13 seiten)

Seite drucken

High Energy Sports Inc

your parachute container does not have grommets pre-installed in your harness please

contact the harness manufacturer or give us a call.

4. S-fold the parachute bridle into the bottom 1/3 of your parachute container. Leave enough

bridle extending out of the parachute container side (just above the bar tack) to have the

covered loop reach your carabiner. Make sure there are no twists or knots in the bridle.

5. Push the parachute into the container and secure the safety lock system.

To secure the safety lock system line up corresponding grommets located on the

Velcro flap.

With the parachute deployment handle on the outside of each grommet thread the

bungee loop through both grommets.

Insert the curved pin located on your parachute deployment bag handle through the

bungee loop peaking through the grommets on the outside of your parachute

container.

Repeat this process to secure the second safety lock.

If you have any question as to whether your system is secured properly, try to open

the Velcro closure without pulling on the parachute deployment bag handle. If

the parachute container opens freely, your safety lock system is not properly

installed. Next try to open the Velcro by pealing the parachute deployment bag

handle away from the deployment bag. The curved pins should slide out of the

bungee loop and allow the Velcro to open.

If your curved pins slide out of the bungee loops before you exert pressure on the

handle you may need to shorten the bungee loop. To do this simply slide the

knot in the bungee towards the looped end.

6. Secure the top and sides of the Velcro on your parachute container. The more force you

apply to the Velcro the better it will close.

7. Attach the looped end of your bridle to your carabiner. Make sure that your bridle is

opposite the carabiner gate. Secure the bridle to your harness as prescribed by your harness

maker. Make sure you do not have excess bridle that may get caught on anything.

8. If desired attach a safety from your harness main strap directly to your parachute bridle

bypassing the carabiner. This safety should be able to withstand 4000 pound load. It is your

backup in the event of a carabiner failure during deployment.

1. Be sure the handle releases the safety pins before it pulls on the deployment bag.

2. Practice hanging in your harness and pulling your parachute out of the container.

want to release properly. You can add foam to the bottom of your parachute container to help the

parachute ride higher in your harness container.

3. Do the "knee test" to assure that your parachute is secure.

After you place your parachute into your harness:

Note: If your parachute is too small for your parachute container, the handle may not

714-632-3323