DynaSample XPression Wie man einrichtet - Seite 2
Blättern Sie online oder laden Sie pdf Wie man einrichtet für Zubehör DynaSample XPression herunter. DynaSample XPression 3 Seiten. Ewi5000 setup
Auch für DynaSample XPression: Schnellstart-Handbuch (6 seiten), Handbuch (4 seiten)
Seite drucken
1st valve - MIDI Volume (MIDI Controller # 7)
2nd valve - Aftertouch
3rd valve - MIDI Breath Control ( MIDI Controller # 2)
Side button - MIDI Expression Controller ( MIDI Controller # 11)
1st trill - Breath to variable MIDI Velocity
2nd trill - Extra Controller to variable MIDI Velocity
No keys at all - All dynamic controllers off and Velocity at fixed value
More than one controller can be made to send at the same time by holding two or more keys while hitting the
PROGRAMMING BUTTON.
Make sure that pitchbend on the MIDI-EVI is calibrated correctly (when centered you should see the two
vertical lines in the middle of the second line of the XPression's display and no asterixes to the right of it).
Also make sure that the breath threshold and gain are set up high enough so that the XPression responds
immediately. If set too low you will feel an obvious latency.
The EWI-USB will be set up automatically if it is connected during start up.
(Make sure to backup your current EWI-USB settings if you need them as they will be overwritten!)
The setup of all EWI-USB hardware parameters can be edited in [Utility] and will be remembered.
Setting up the Yamaha WX5:
Increase the breath sensitivity / gain until you don't feel any latency when playing.
Set the reed pitchbend to "thight lip" and to send pitchbend. Use the full pitchbend range.
nd
(You can see the pitchbend on the 2
line of the remote display)
Set the breath controller to CC2 (breath) and the velocity to "variable MIDI Velocity".
Setting up the Synthophone:
Turn off volume control (CC#07) by using this key combination:
Set the highest level (level 5) to stop sending CC7:
- side Bb, F & Eb
increase VOLUME level + 1
It is best to set the Synthophone to send the full pitchbend range (level 5):
- side C, F & Eb
increases symmetrical PITCH BEND
Make sure that the breath level is set to the full range (level 5 = default):
- side Bb, D# & Eb
increase BREATH level +1
Make sure that aftertouch is turned off (default):
- side C, D# & Eb/C
reset AFTERTOUCH to level 0
The velocity range is not important since the XPression will generate a dynamic velocity that is not available
on the Synthophone when using other sound modules.
For this the "Synthophone Note & Velocity Fix" needs to be set to "accurate" and the "Percussive Velocity or
Dynamic Controller" needs to be set to "dynamic". Both parameters are located in [Global] and will be set up
correctly when recalling "backup 3" in [Utility]. So you don't have to do anything.
NEW:
If you are having problems controlling the intonation on the Synthophone you might want to change to
"Pitchbend Curve" in [Global] to a higher level (e.g. 50). This can interfere with the vibrato response, though.
You can also set additional pitchbend curves per patch in [Edit] for patches that use a higher pitchbend range
than one semitone. [EDIT] "Pitchbend Range": curve negative = smooth, positive = hard
It's a good idea to turn on the Synthophone first but DO NOT PLAY or send any MIDI data during the startup
of the XPression. The best way is to connect the MIDI cable after both units are already started up.