Autonomic Mirage MMS-1e Setup-Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Setup-Handbuch für Server Autonomic Mirage MMS-1e herunter. Autonomic Mirage MMS-1e 18 Seiten.
Seite drucken
Wired Ethernet Settings
In this section, you can configure your server's network connection to automatically use a
network DHCP server to obtain its IP address and network settings, or you can manually specify
a static IP setting.
If you choose to use Manual Configuration be sure to enter the correct settings for IP Address,
Subnet Mask, Gateway, and DNS 1 & 2. If you are unsure how to configure these settings it
would be best to leave your connection set to
administrator.
WARNING
Setting these values incorrectly can prevent the MMS from connecting to your network, and
could make the server unreachable. If this happens, there is a utility available at
http://www.autonomic-controls.com/support_faq_mms.php
Logging
This section allows you to upload internal server logs files and, optionally, your media database
if you are instructed by the Autonomic support team. These log files will be sent directly to our
support staff.
Restarting Your Server
The
section contains a link to restart your MMS. Clicking this link will make your MMS
Utilities
unresponsive for 2-3 minutes while it shuts down and restarts itself.
Display Settings
The Display Settings tab allows you to configure the Mirage on-screen display options. Your
monitor or TV display should be plugged into the HDMI before turning on the server.
It is important to remember to press the Save button at the top of this tab after you are finished
making any changes to this page. If you navigate away from this page without pressing Save,
your changes will be lost.
NOTE
Some HDMI receivers and switches are not compatible with the MMS. If you receive an error
message on screen, or if the MMS seems non-responsive, try plugging the HDMI cable directly
into the display, bypassing any adaptors, switches, or AV receivers.
Audio Settings
The
Source Settings
It is important to remember to press the Save button at the top of this tab after you are finished
making any changes to this page. If you navigate away from this page without pressing Save,
your changes will be lost.
The
section allows you to configure the MMS for RS-232 or IP connection to a
Audio System
Mirage multi-room amplifier.
The
section allows you to enable or disable each output, rename them, configure
Connections
maximum sampling rate and bit depth (digital outputs only) and set each to variable or fixed
gain output for pass-through control of volume, mute and zone power on the amp from the
monitor or TV display and web interface.
7 of 15
Autonomic (DHCP)
tab allows you to configure audio settings and system outputs on the MMS.
or contact your network
which can help you recover.
Mirage Media Server Set Up