Autopage C3-RS-915 LCD Betriebshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Autoalarm Autopage C3-RS-915 LCD herunter. Autopage C3-RS-915 LCD 17 Seiten. Professional 2-way lcd remote car starter & alarm system with built in temperature & voltage sensor and two-way serial port data link

Seite drucken

SVMASTER

Get into/out valet mode using the ignition key.

Enter Valet Mode:

a). Under disarm mode, turn the ignition to "ON" position.

b). Press and hold valet switch for 2 seconds until the LED turns ON solid. The LED will remain

on as long as the system is in 'valet mode'.

Exit Valet Mode:

a). Turn ignition 'ON'.

b). Push and hold valet switch for 2 seconds, The LED will turn off indicate the system are exiting

the valet mode.

J. CAR LOCATOR

Under armed mode, press the

The parking light will flash 12 times, for you to easily locate your car.

K. PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the alarm in case of emergency.

1. Press and hold the

2. During panic mode, the normal function of this transmitter button will be disabled. The transmitter

buttons can be used to lock and unlock the door (if the option is installed), however once the

pressed, the vehicle's starter disable device, (where installed) will be disengaged allowing the vehicle to start.

3. To stop the alarm, press the trunk

4. If the button is not pressed, the alarm will automatically stop after 30 seconds.

L. TRIGGER THE SYSTEM

When armed, your vehicle is protected as follows:

Light impact will trigger the warn-away signal.

Heavy impacts / Doors open /(if installed) Hood open / (if installed) Trunk open / Turning on the

ignition key will trigger the programmed sequence.

The starter disable relay (if installed) prevents the vehicle's starter from cranking. The siren, horn,

parking lights, and dome light will turn on alerting of an intrusion for 30 seconds. Then it will stop

and automatic reset and re-arm. If the any one of the sensors or detectors is still active, the alarm

system will sound a maximum of 3 times of 30 seconds cycles.

NOISE ABATEMENT CIRCUIT:

repetitive trigger sequences due to faulty door pin switches or environmental conditions such as

thunder, jackhammers airport noise, etc.

Here's how "Noise Abatement Circuit" works: The alarm triggers five times. Each time, the same

sensor or switch has triggered the alarm; the "Noise Abatement Circuit" will interpret this pattern of

triggers as a false alarm. After the third trigger, the "Noise Abatement Circuit" ignores, or bypasses,

that sensor or switch until a different sensor or switch is trigger.

"Noise Abatement Circuit" covers doors (Hood/Trunk) differently: If the alarm is triggered by an open

door for Three full cycles, the doors will be bypassed until the trigger ceases.

M. ANTI CAR- JACKING (Programmable)

Warning: If you don't need the carjacking function in this alarm system, be sure to set carjacking

feature "OFF". This systems default setting is "OFF" for all carjacking modes.

ACTIVE ANTI CAR JACKING:

1.When the Ignition is ON press

area, then press

SVMASTER

C3 RS915 REV. O1

button to active car locator function. The siren will chirp 6 times.

button for 3 second. The alarm will immediately sound.

button on the remote control

Your system has a "Noise Abatement Circuit". It prevents annoying

button four times while "CAR JACK" is flashing in the text

button to activate Anti Car-Jacking mode or

http://www.msvmaster.lv

and

button is