Dynasound DS1338 Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch für Redner Dynasound DS1338 herunter. Dynasound DS1338 4 Seiten. Soundmasking / paging speaker

ELECTRICAL CONNECTION

All speakers will be connected in parallel. Run the zone wiring so that the wires

pass each speaker. Start at the speaker at the END of the zone Strip the two zone

wires. Twist the black wires together and twist the red (or white) wires together. Put

a crimp connector on each connection and stuff the connections into the speaker

and then screw down the strain relief clamp. Verify the speaker is on the 1W set-

ting. Move to the next speaker and pull up any slack from the previous speaker

and cut the zone wire. The zone wire should be suspended well above the ceiling

and not left in loose loops. Some local codes require the wire to be suspended

between the speakers. Use fire rated wire ties, where required by code, to dress

the zone wires to speaker suspensions and to ceiling attachments. Strips both

ends and twist all black wires together and twist ll red (or white) wires together.

Generally there are three wires of each color, the two zone wires and the wires into

Dynasound, Inc. 6439 Atlantic Blvd. Norcross, GA. 30071

PROPER INSTALLATION TECNIQUES

All electrical connections should be inserted into the speaker

enclosure before tightening the strain relief. In addition, the

wires should be attached to the hanging wire, using wire ties,

as illustrated.

Fastening the lead wires at these two points while adjusting the

speaker to be level is normally all that is needed to keep the

speaker in the appropriate position.

Leaving the speaker connections outside the enclosure is bad

wiring practice, and provides less ability to level the speaker.

In some cases where thereis difficulty getting the speaker to

hang correctly, the balance of the speaker can be changed by

bending the eybolt, very slightly, in the direction of the low point

of the speaker.

It is not critical that the speaker be perfectly level, other than for

aestetic reasons.

800.989.6275