High tech health CBV3 Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Massage High tech health CBV3 herunter. High tech health CBV3 9 Seiten.

Seite drucken

troubleshooting

problem

possible cause

Device is on (lights illuminated

The device is not being used

on the LCD display) but cannot

correctly. Check corrective

feel the electrical stimulation

action procedure.

through footpads.

Not placing both bare feet on

the foot pads at the same time.

Your feet may be dry.

You may be dehydrated.

The "SOLE" intensity level may

be on too low a setting.

Solution

We call it "The Hand Test". Test

the device by placing both bare

hands at the same time on each

of the foot pads (left hand on left

pad, right hand on right pad).

Increase the "SOLE" intensity

up in increments of 10 (up to

maximum of 99) until you can

feel the stimulation. If you can

feel the stimulation through your

hands then the device is working.

If on 99 you still cannot feel the

stimulation then please contact

your authorised dealer.

Ensure that your feet are bare

and each foot is placed on

each of the foot pads at the

same time. Keep increasing

the "SOLE" intensity up to a

maximum of 99 until you feel

the stimulation.

Moisturise the soles of your feet

preferably with a heel balm high

in urea from your local pharmacy

and try the procedure again. You

may also have to increase the

"SOLE" intensity level.

Drink plenty of water before

and after using the device. The

device uses your body to create

the electrical circuit. Water

is an excellent conductor of

electricity and if your body is

less hydrated (below 0%) then

the stimulation may be less.

Therefore it is important to

always remain well hydrated.

This is a very safe device. Keep

increasing the "SOLE" intensity

level towards 99 until you feel

the stimulation. Ignore your

friends and family if they were

able to feel it on much lower

levels – everyone is different!

Also, you may find that you have

to increase the "SOLE" intensity

level as you get used to the

therapy. The aim is not to get to

99 but to find a setting that is

comfortable for you.

troubleshooting continued...

problem

possible cause

No power or lights to the

DC Adaptor not switched on at

device when switched on.

mains socket or DC Adaptor not

plugged into device properly.

The Device is not vibrating.

The device DOES NOT VIBRATE. Read instructions

The Body electrode pads have

The electrode pads will

lost their adhesive / stickiness.

eventually deteriorate

with regular use. They are

consumables. To guarantee

maximum life, ensure that

your skin is free from dirt,

oil and lotions.

My legs are aching

You may have the "SOLE"

after treatment.

intensity on too high a setting

and your muscles are being

overworked.

Visit our website for accessories and great innovative health products

Solution

Check mains socket power

is switched on and the DC

Adaptor is plugged into

the device correctly. If still

not working – contact your

authorised dealer.

on correct use.

Dab a small drop of water

onto the sticky side of the

electrode pad and rub into the

surface. This should improve

the adhesiveness. Also use

the hard white plastic holders

to store the pads. At the end

of the electrode's life, please

contact your authorised dealer

to purchase replacements.

Leave adequate time after each

treatment to allow the muscles

to recover (just like after

vigorous exercise!). On your

next session start on a lower

setting (where you can feel the

mild electrical stimulation and

it is comfortable) and reduce

the duration until your muscles

have acclimatised to the

stimulation.