Dynasty Fireplaces DY-BEF45 Installations- und Betriebsanleitung für den Hausbesitzer - Seite 13

Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für den Hausbesitzer für Innenkamin Dynasty Fireplaces DY-BEF45 herunter. Dynasty Fireplaces DY-BEF45 15 Seiten.

Seite drucken

Multifunction Infrared Remote Handset

BUTTON

ON: Turns on.

Note:

All the functions are off in the standby mode,

it will memorize the working condition of flame

effect and heating.

ON/OFF

OFF: Returns the unit to standby mode.

Controls the flame effect.  

Cycles through 5 levels of flame effects.

FLAME

Press once turns Fan on, and 10s later Low

heat on. (Pilot lights illuminated ●○)

Press again turns on High heat. (Pilot lights

illuminated ●●)

Press third time turns heat off. 10s later fan

off (Pilot lights illuminated ○○)

HEATER

Controls the thermostat setting.

Thermostat: Automatically turns the heater

on and off to maintain the temperature.

If the thermostat is set below the room

temperature, the heater will turn off.

NOTE: The thermostat only works when the

heater is on.

1) NOTE: The heat will not change as the room

temperature

temperature shows on the remote screen.

TEMP

NOTE: It will change between C and F after

pressing

corresponds

operated in the standby mode, but the

temperature still displays on the remote

control screen.

Controls the timer settings.

The timer turns off the fireplace at the set

time, from 0.5 hours to 9.0 hours.

TIMER

Controls the LED light strips at the bottom of

the fuel bed.

FUEL

BED

FUNCTION

change

when

the

button

for

16-28C.

1. Press. The flame effect and the

remote control functions are enabled.

The flame setting will display on the

remote control screen.

2. Press. The flame effect and all the

functions will turn off. The remote

control screen will go blank.

1. Press once to turn the flame

effect on.

2-4. Press again to cycle through 5

flame effects.

1. Press. The heater turns on low

heat.

2. Press. The heater turns on high

heat.

3. Press. Turn off the heat.

4. When the heater is on without

flame or fuel bed, 3

light on with 5% brightness to

indicate the heater is on.

1. Turn the heat on. Press.

The temperature displays 24C.

2-13. Press again to increase the

temperature by 1C interval up from

16C to 28C (maximum setting).

14. Press again. The thermostat

turns off. No temperature is

displayed.

there

is no

15. Press. Start at 23C.

3s.

60-84F

cannot

1-10. Press .

Timer setting: 0.5H,

1.0H, and then each

hour up to 9.0H.

11. Press. Off. No time is displayed.

1. Press once to turn the fuel bed

light on.

2-14. Press again to cycle through

14 color options of the fuel bed.

ACTION & INDICATION

fuel bed will