Dynasty Fireplaces DY-BTW48 Installations- und Betriebsanleitung für den Hausbesitzer - Seite 12

Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für den Hausbesitzer für Innenkamin Dynasty Fireplaces DY-BTW48 herunter. Dynasty Fireplaces DY-BTW48 16 Seiten.

Seite drucken

BATTERY INFORMATION

Remote Control Battery
 This remote control uses two AAA batteries (included).
 Instructions for battery installation are inside the Remote Control battery compartment.
 Always replace the battery in the remote control with the same type of battery.
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an
explosion. Dispose of batteries at your local hazardous material processing center, or
as required by local ordinances.

OPERATION

Read and understand this entire owner's manual, including all safety information,
before plugging in or using this product. Failure to do so could result in electric
shock, fire, serious injury, or death.
Power
Make sure the ON/OFF switch, located on the control panel, is in the OFF position. Plug the power
cord into a 110~120 Volt 15 Amp outlet (see IMPORTANT SAFETY INFORMATION on Pages 3
and 4). Make sure the outlet is in good condition and that the plug is not loose. NEVER exceed the
maximum amperage for the circuit. DO NOT plug other appliances into the same circuit.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature (212F / 100C), the heater will automatically turn OFF. To reset:
1.
Unplug the power cord from the outlet.
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait at least 5 minutes.
3.
Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they
are, use a vacuum to clean the vent areas.
4.
With the POWER switch in the OFF position, plug the power cord back into the outlet.
5.
If it switches off again, UNPLUG THE HEATER RIGHT AWAY! Have the outlets, wiring,
and breaker box inspected by a professional. Make necessary repairs before using the
heater.
Heater Rating
Maximum Heat Output: 1500 W (5120 BTU); Maximum Heating Area: 400 square feet.
Methods of Operation
CONTROL PANEL: Located on the front glass panel of the fireplace (see figure below).
Controls ON/OFF, FLAME EFFECT, HEATER and FUEL BED.
REMOTE CONTROL (Battery included):
Controls ON/OFF, FLAME EFFECT, HEATER, THERMOSTAT, TIMER and FUEL BED.
Review the IMPORTANT SAFETY INFORMATION on Pages 3 and 4 before operating.
11