Autoplugin Therminal V2 Installationshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Installationshandbuch für Automobilelektronik Autoplugin Therminal V2 herunter. Autoplugin Therminal V2 12 Seiten.

Seite drucken
6.1. Indication of
6.
Indication of
heater startup
the heater
status by the
perimeter
lighting and
by the turn
signals in the
6.2. Indication of
rear-view
command reception
mirrors
from remote control
6.3. Indication of
operated heater,
started by remote
control
6.4. Indication of
operated heater,
started by DIS (direct
or program start)
6.5. Indication of
operated heater,
started by additional
button
6.7. Flashing
frequency for the
indication of heater
autonomous operation
7.
7.3. Send SMS
Notifications
«ALARM Trunk or
Hood»
7.4. Send SMS
«ALARM Doors»
8.
8.1. Default Settings
Service
menu
* Factory setting
Recommended settings is marked in italics
1
–RCP will turn off the heater if the battery voltage becomes lower than preset
8
6.1.1 *Off (only switching off the lighting)
6.1.2 Switch the lighting on for
6.1.3 Switch the lighting on for 2 sec
6.1.4 Switch the lighting on for 3 sec
6.1.5 Switch the lighting on for 5 sec
6.1.6 Switch the lighting on for 7 sec
6.1.7 Switch the lighting on for 10 sec
6.2.1 Off
6.2.2 *Three flashes
6.3.1 *Off
6.3.2 On
6.4.1 *Off
6.4.2 On
6.5.1 *Off
6.5.2 On
6.7.1 One flash within 3 sec
6.7.2 One flash within 5 sec
6.7.3 * One flash within 10 sec
6.7.4 One flash within 15 sec
7.3.7 *In the case when the heater has not
started or shut down during operation (i.e.
error occurred with the heater)
7.3.8 Do not send
7.4.2 *In the case when the heater has
finished operation with no errors or when
the engine has been run during the heater
operation
7.4.8 Do not send
8.1.1 Apply factory settings
1
sec