Dynatech V PLUS Series Gebrauchsanweisung - Seite 7
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Verstärken Dynatech V PLUS Series herunter. Dynatech V PLUS Series 14 Seiten.
Seite drucken
V-3000 PLUS / V-4000 PLUS
P R O F E S S I O N A L
P O W E R
A M P L I F I E R
SET UP
Front Views & Rear Views | Introduction | Front Panel | Rear Panel |
| Operation Mode | Protection | Specifications
SET UP
INPUTS -
The V PLUS Series allows you to use XLR 3-pin input
Male XLR Pin Configuration
connector per channel, a XLR female jack for balanced
connections to connect the output signal from a mixer, cross-over
or EQ to your V PLUS Series power amplifiers. A balanced
2
1
3
connection is recommended for cable runs longer than 20ft. When
2 Hot (+data)
1 Ground / Return / 0v
constructing your own XLR cables follow the pin configuration
described below for proper connections. You may use the two XLR
3 Negative (-data)
"Input Thru" jacks to jump a parallel connection to another amplifier
or other device. For example: Connect a XLR cable to the input of
Figure
4
channel one. You may now connect a XLR cable from the channel
one "Input Thru" jack to the input jack of another amplifier's
channel one input. This will reduce the use of "Y" cables.
STEREO CONNECTIONS USING
THE NEUTRIK SPEAKON OUTPUT CONNECTORS:
Recent regulatory requirements in Europe have outlawed the use of the
dual banana plug and force amplifier users to terminate their speaker
cables with spade lugs or bare wire ends. This is not advantageous to
most users that want to reconfigure their systems or quickly change out
an amplifier. The Neutrik Speakon connector provides the most
convenient solution to this problem, eliminating the need for spade lugs
or bare wire end cables. Major speaker manufacturers have been using
Speakon connectors on their products for years, so chances you are
ready to use the Speakon connection. With Speakon connectors, you
can connect straight from the amplifier to the speaker. The Speakon
connector used on this amplifier meets all known safety regulations.
Once wired correctly, the connector cannot be plugged in backwards,
5
Figure
causing the type of inverted polarity situations that have become
common with banana hookups. This connection will provide a safe,
secure and reliable method of connecting your speakers to your new
amplifier. You can purchase the Speakon NL4FC connectors from your
local audio dealer.
page 6