Dynatech BBM Zusätzliche Wartungs- und Reparaturanweisungen - Seite 7

Blättern Sie online oder laden Sie pdf Zusätzliche Wartungs- und Reparaturanweisungen für Säge Dynatech BBM herunter. Dynatech BBM 10 Seiten. Mini masonry saw

Seite drucken

BBM & YBM INSTRUCTIONS [May 2004]

Adjusting the Cutting Head Depth

1. Pull up and twist the pivot lock knob to allow the

cutting head to rest in the full upright and raised

position. Do not lock the head in position. Make

sure the depth lock is disengaged so that the cutting

head pivots freely and is as far up as possible.

2. Using a 5mm Allen wrench, loosen the set screw on

the motor side of the pivot bar. Do not remove the

set screw.

3. Remove the 17mm hex head cap screw on the

motor side of the cutting head pivot bar.

4. Remove the Phillips head screws and pull the

washer out to expose the end of the pivot bar.

5. Using a Phillips head screw driver, remove the two

screws holding the cover located under the back of

the cutting head directly below the pivot lock.

6. Using a 4mm Allen wrench, loosen the two set

screws on the cutting head main angle bracket.

Only loosen the two 4mm screws located above and

below the torsion spring dowel pin.

7. Push the cutting head to the highest possible raised

position and then tighten the heck out of the two

4mm set screws on the cutting head main angle

bracket.

Tighten the bottom set screw first then

tighten the set screw facing the front of the saw.

These set screws must be tightened until they "scream" or

the cutting head will slip when the operator presses down

on the handle.

NEVER ATTEMPT ANY OF THE INSTRUCTIONS WITH POWER CONNECTED TO SAW!