HighGear Loft Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Siehe HighGear Loft herunter. HighGear Loft 19 Seiten. Altiware series

CARE AND MAINTENANCE

Your Outdoor Wrist Instrument should be protected from shocks, extreme heat and extended exposure to direct sunlight.

As the owner of the product you should only perform service procedures related to the changing of the battery as shown

in this manual. You should NEVER attempt to disassemble or otherwise service your watch. When not in use, your watch

should be stored in a clean, dry area at room temperature.

If your Outdoor Wrist Instrument gets dirty it should be carefully wiped clean using a moist cloth. Care should be taken

when cleaning the lens not to rub dirt into the surface as it can become scratched and hard to read.

Do not store the transmitter when wet as this may shorten the battery life. The transmitter should be stored flat rather

than folded and should never be bent or stretched as this may damage the electrodes. Never lay your heart rate

transmitter on a metal surface as this will quickly drain the battery.

ALTIWARE SERIES

CARE AND MAINTENANCE

The Loft uses a common CR2032 3v Lithium battery in both the watch and heart rate transmitter. These batteries are

commonly available at camera, bicycle, electronics and drug stores. Normal battery life for the watch is approximately 1yr.

Heavy use of the Altimeter, Heart Rate or Backlight system may significantly reduce battery life.

A blank display or inaccurate altimeter or heart rate readings are indications that the battery is getting weak and

should be replaced.

1. Remove battery door using a coin.

2. Turn the black plastic battery retainer counter-clockwise.

3. Carefully remove the retainer and old battery. Do not damage the O-ring seal.

4. Place a fresh battery in the battery compartment with the positive (+) side facing up.

5. Slide the battery retainer over the battery and position the tabs into their appropriate holes.

6. Both the battery and battery retainer should be positioned underneath the gold tab. Slide the

retainer counter clockwise.

7. Replace battery door using a coin.

8. If the O-ring has been damaged, replace it before reinstalling the battery door. Most jewelers and

watch shops should have replacement O-ring seals.

Extreme care should be taken when replacing the battery to ensure the unit remains fully water resistant. Failure

to properly replace the battery and correctly seal the unit may cause the unit to become damaged and may void

the warranty.

Lithium batteries of the type used in this watch are extremely sensitive to improper storage. It is our experience

that many of the batteries being sold as new have been stored improperly and are already dead or nearly dead

when purchased. If you replace the battery in your watch and it does not become functional, do not assume there

is something wrong with the watch. Try another battery and see if that solves things, most of the time it will.

LOFT