Adept Audio AMP200 Installationshandbuch - Seite 15
Blättern Sie online oder laden Sie pdf Installationshandbuch für Redner Adept Audio AMP200 herunter. Adept Audio AMP200 20 Seiten. Landscape speaker system
Seite drucken
EQ PRESET:
Flat – EQ bypassed
EQ1 – High Freq & 0dB <150Hz
EQ2 – High Freq & -2dB <150Hz
EQ3 – High Freq & +2dB <150Hz
EQ4 – High Freq & +5dB <150Hz
Sub – Subwoofer (low frequencies only)
Impedance Switch
The AMP200 has an impedance switch with two settings: 4/8 ohms,
and 8 ohms (bridged). Use the 4/8 ohms setting.
Level Controls
The AMP200 has two screwdriver-adjustable level controls on the front
panel, for left- and right-channel volume. At first, set these at about 9
o'clock (pointing to the left). Play some modern rock or R&B music that
is recorded at a loud level. Now turn the volume control on your sound
source (a multichannel audio controller, streamer, etc.) all the way up,
then turn up the AMP200's level controls until you reach the maximum
volume you want. Make sure you do not set the level controls so high
that the speakers distort.
TESTING THE SYSTEM
Get the system playing, then go up close to each of the satellite speakers
and the subwoofer to make sure all of them are working. If any one
speaker is not working, check the connection for that speaker. If multiple
speakers are not working, start by checking the connection for the
disconnected speaker that's closest to the subwoofer, then check the
other connections down the line until you get all the satellites working.
Play a tune with vocals. Stand equidistant from the first left/right pair
of satellite speakers. The vocals should mostly seem to coming from a
point between the left and right speakers. If the vocals sound spacey,
like they're coming from all around, check the positive and negative
polarity connections for that pair of speakers. Repeat with all the other
left/right pairs.
15