DCS IR48 Einbauanleitung

Blättern Sie online oder laden Sie pdf Einbauanleitung für Lüftungshaube DCS IR48 herunter. DCS IR48 2 Seiten. Professional vent hood ir panel kit

Seite drucken

PROFESSIONAL VENT HOOD IR PANEL KIT

INSTALLATION INSTRUCTIONS

ELECTRICAL SHOCK WARNING

Make sure the unit is disconnected from the power source. Serious injury or death could

result.

WARNING

To avoid any electrical shock, the installation of the IR lamp kit should be done by a

qualified electrician and before starting the installation of the hood.

MODELS:

IR30, IR36, IR48

HARDWARE INCLUDED

Description

IR30

IR Bulb (175W-PAR)

IR Lamp Panel with IR bulb switch

Aluminum label

IR36

IR Bulb (175W-PAR)

IR Lamp Panel with 2 IR bulb switches

Aluminum label

IR48

IR Bulb (175W-PAR)

IR Lamp Panel with 2 IR bulb switches

Aluminum label

Lamp connector

IR lamp wiring

Quantity

Screw (2)

IR lamp panel

IR bulb

Fig. 01

5900 Skylab Road, Huntington Beach, CA 92647

Tel: 714.372.7000 • Fax: 714.372.7001

Customer Care: 888.281.5698

www.dcsappliances.com

P/N 17780 Rev. B 11/04

INSTALLATION INSTRUCTIONS:

1. Apply protective aluminum labels on

left hand and right hand side prior to

removing existing IR lamp panel (see

Fig. 02).

2. Remove the original panel by unscrew-

ing the two side screws (see Fig. 01)

CAUTION: Hold the panel in place while

removing the screws as the panel may

shift once the screws are removed.

3. Connect the IR lamp wiring to the lamp

connector (Fig. 03). Carefully install IR

panel using screws from step 2.

4. Remove and discard the protective

aluminum labels from the hood.

Aluminum label

Fig. 02

Fig. 03