COPERTINA inglese 0612 Anweisungen und Warnungen - Seite 13
Blättern Sie online oder laden Sie pdf Anweisungen und Warnungen für Eiswürfelbereiter COPERTINA inglese 0612 herunter. COPERTINA inglese 0612 15 Seiten. Automatic modular ice-cube maker
Seite drucken6.1 CLEANING INTERNAL PARTS
The appliance will have already been cleaned in the factory. However, you are advised to wash the
internal parts again before using the appliance. Make sure that the power supply cable is unplugged
before carrying out the above cleaning operation.
See cleaning and sanitizing manual for information regarding cleaning operations.
For cleaning operations in general, use an ordinary detergent for washing dishes or a solution of water
and vinegar. Rinse thoroughly with plenty of cold water and remove any ice that may have been
produced during the first 5 cycles after cleaning, together with any ice present in the bin.
It is advisable to avoid using abrasive detergents or powders, since these might damage the finish.
6.2 START-UP
When you start up the appliance the first time, or when you start it up again after a long period at
a standstill, fill the basin manually with water.
This filling operation must be carried out by removing the front panel (Fig. 7), raising the flaps and
pouring the water directly into the basin (Fig. 8).
In the cycles subsequent to the initial one, the appliance will be filled with water in a fully automatic way.
Once the appliance has been correctly connected to the electricity mains, water mains and water drain
system, it can be started up as follows:
a) turn on the water supply tap(s) (7 in Fig. 4)
b) insert the plug (if any) in the socket and switch on the power supply by means of the relative switch
fitted during the installation phase (6 in Fig. 4)
Switch on appliance by pressing the luminous switch (14 in Fig. 9).
For appliances that are connected permanently to the electricity mains, turn on by means of the switch
on the outside of the appliance, fitted during the installation phase.
Should the appliance fail to produce ice, before calling on the Authorized Technical Service Centre, first
check carefully that:
• the water supply tap(s) (7 in Fig. 4), fitted during the installation phase, has/have been turned on
• electric power is reaching the appliance; the plug (if any) is properly inserted in the socket, the switch
(6 in Fig. 4) is in the "ON" position, and the push button (14 in Fig. 9) is lighted up
Furthermore:
• if there is excessive noise, make sure that the appliance is not touching furniture or sheet metal which
can give rise to noise or vibrations
• should any trace of water appear, check the drain hole of the bin to ensure that it is not clogged, that
the water fill and drain pipes are correctly connected and are not throttled or damaged
• make sure that the temperature of the air or water does not exceed the installation limit values
(see paragraph 5.2)
• make sure that the water inlet filter is not clogged (see paragraph 9.1)
• make sure that the spray nozzles are not clogged with scaly deposits
If the fault still persists after the above inspections have been made, turn off the electric power source
by means of the switch fitted during the installation phase, pull out the plug (if any) from its socket, turn
off the tap(s) connecting the appliance to the water mains, and contact the nearest Authorized Technical
Service Centre.
To obtain a faster and more efficient reply when you call the Centre, state the model of the appliance
precisely, together with its serial number or manufacturing number. This information is given on the
serial N° plate (Fig. 1) affixed to the rear of the appliance and on the cover of this instruction manual.
6 START-UP