HighPoint SSD7540 Installationshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationshandbuch für Computer Hardware HighPoint SSD7540 herunter. HighPoint SSD7540 12 Seiten. Using nvme raid aics with the dell precision 3930 rack workstation
Auch für HighPoint SSD7540: Handbuch zur Schnellinstallation (9 seiten), Installationshandbuch (15 seiten), Installationshandbuch (13 seiten), Installationshandbuch (14 seiten), Installationshandbuch (16 seiten), Handbuch zur Schnellinstallation (11 seiten), Installationshandbuch (19 seiten), Handbuch zur Schnellinstallation (6 seiten), Handbuch verwenden (19 seiten)

HighPoint SSD7540 Installationshandbuch
SSD7540 Linux CentOS7.8 Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install Linux
CentOS7.8 on the SSD7540 controller.
For CentOS7.8 (kernel: 3.10.0-1127.el7.x86_64)
Mirror link:
https://mirrors.bfsu.edu.cn/centos/7.8.2003/isos/x86_64/CentOS-7-x86_64-DVD-2003.iso
MD5: ef8195f42f30a23f039eef9891d496ae

2 Installing Linux CentOS7.8 on SSD7540 controller

If you would like to install Linux CentOS7.8 onto drives attached to SSD7540 controller,
please perform the following operations:

Step 1 Prepare Your Hardware for Installation

After you attach your NVMe SSD to SSD7540 controller, you can use SSD7540 EFI
Utility to configure your NVMe SSD as RAID arrays, or just use them as single disks.
Before installation, you must remove all the NVMe SSD, which are not physically
attached to SSD7540 controller, from your system.
Note
SSD7540 only support EFI boot. If you have other SCSI adapters installed, you must
make sure the SSD7540 controller EFI will be loaded firstly. If not, try to move it to
another PCI slot. Otherwise you may be unable to boot up your system.

Step 2 Check System EFI Settings

In your system EFI SETUP menu, change Boot Sequence in such a way that the system
will first boot from EFI CDROM, and then from SSD7540 RAID. Refer to your
motherboard EFI manual to see how to set boot sequence.
If your EFI settings do not support such a boot sequence, you can first set it to boot from
EFI CDROM. After you finish installation, set SSD7540 RAID as the first boot device to
boot up the system.
1. Set UEFI setting with SuperMicro X11DPi-NT motherboard as an example:
a.
Set 'Boot mode select' to 'UEFI';
- 1 -