DYNAVOICE CHALLENGER SERIES Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner DYNAVOICE CHALLENGER SERIES herunter. DYNAVOICE CHALLENGER SERIES 5 Seiten.

Single wire connection bi-wiring terminals

Some DINAVOICE speakers have 4-pole terminals allowing bi-wiring. When connecting with single

wiring, do NOT remove the connectors between low and high sections of the terminal and connect

to the upper terminals as in the figure below

Since everyone has different sound ideals - including audio files - this is also the definition provided

with an X-change terminal. Top of the terminal you will find 3 additional gold plates coated contacts.

These are used to fine-tune the critical midrange area after your own taste. You can choose between -

2 dB / 0 dB / +2 dB / +4 dB. The fact that this field changes, so the whole character of the speaker. You

do not have to therefore change the bass / treble controls on the amplifier to get the sound you

prefer.

DYNAVOICE recommends using amplifiers within a specific power range. However, the most important

thing is that the amplifier has sufficient power reserves for handling peak sand transient in the music

signal.

The power rating figure of a loudspeaker is a very unprecise figure. Since the energy in the music signal

varies, neither peak nor average value is relevant. A power rating of e.g. 100WRMS says only that you

can play a continuous tone of 1kHz at this output. It does not mean that you can turn the volume all

the way up on a 100W amplifier and expect clear sound and healthy speakers.