HighPoint SSD7505 Installationshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationshandbuch für Gehege HighPoint SSD7505 herunter. HighPoint SSD7505 12 Seiten. Using nvme raid aics with the dell precision 3930 rack workstation
Auch für HighPoint SSD7505: Installationshandbuch (14 seiten), Installationshandbuch (15 seiten), Handbuch zur Schnellinstallation (6 seiten), Handbuch zur Schnellinstallation (8 seiten), Installationshandbuch (14 seiten), Installationshandbuch (16 seiten), Installationshandbuch (19 seiten), Handbuch verwenden (19 seiten)

SSD7505 Linux CentOS7.8 Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install Linux

CentOS7.8 on the SSD7505 controller.

For CentOS7.8 (kernel: 3.10.0-1127.el7.x86_64)

Mirror link:

https://mirrors.bfsu.edu.cn/centos/7.8.2003/isos/x86_64/CentOS-7-x86_64-DVD-2003.iso

MD5: ef8195f42f30a23f039eef9891d496ae

If you would like to install Linux CentOS7.8 onto drives attached to SSD7505 controller,

please perform the following operations:

After you attach your NVMe SSD to SSD7505 controller, you can use SSD7505 EFI

Utility to configure your NVMe SSD as RAID arrays, or just use them as single disks.

Before installation, you must remove all the NVMe SSD, which are not physically

attached to SSD7505 controller, from your system.

Note

SSD7505 only support EFI boot. If you have other SCSI adapters installed, you must

make sure the SSD7505 controller EFI will be loaded firstly. If not, try to move it to

another PCI slot. Otherwise you may be unable to boot up your system.

In your system EFI SETUP menu, change Boot Sequence in such a way that the system

will first boot from EFI CDROM, and then from SSD7505 RAID. Refer to your

motherboard EFI manual to see how to set boot sequence.

If your EFI settings do not support such a boot sequence, you can first set it to boot from

EFI CDROM. After you finish installation, set SSD7505 RAID as the first boot device to

boot up the system.

1. Set UEFI setting with SuperMicro X11DPi-NT motherboard as an example:

Set 'Boot mode select' to 'UEFI';

- 1 -