CopperOptics PairGain PG-Flex FRE-765 List 5 Handbuch - Seite 13
Blättern Sie online oder laden Sie pdf Handbuch für Fernsteuerung CopperOptics PairGain PG-Flex FRE-765 List 5 herunter. CopperOptics PairGain PG-Flex FRE-765 List 5 20 Seiten. Remote terminal enclosure
Auch für CopperOptics PairGain PG-Flex FRE-765 List 5: Handbuch (8 seiten)
Seite drucken
Revision 01
7. Mounting
7.1
The FRE-765 mounts on a pole or a wall. Follow local practices to ensure a secure mounting.
Mount the FRE-765 for easy access to the cable entry points on the bottom of the enclosure. Provide
ample room to open the door completely.
7.2
For pole mounting the FRE-765, use the Pole Mounting Kit PN 150-1397-00. Follow the
instructions that are included to install the pole mounting bracket. Then, mount the FRE-765 to the
bracket. Do not install any cabling until the FRE-765 is securely mounted.
7.3
When required, install the grommet into the base of the FRE-765 (Figure 3) prior to performing any
wiring.
1
Select only one concentric knockout hole on the FRE-765.
2
Remove the largest knockout so that the entire hole is open.
3
Install the grommet from the outside of the FRE-765. (Hint - Hold it at an angle to the hole and
roll it into position.)
4
Ensure the lip of the grommet rests on the bottom of the FRE-765 around the knockout hole.
5
Use an appropriate tool to open the required hole(s) in the bottom of the grommet.
PG-Flex FRE-765
June 2, 1997
Figure 3. Installing the Grommet
PairGain Engineering - Plant Series
Section 363-765-105
Page 11