CopperSmith CSRB-8 Installationsanleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Fan CopperSmith CSRB-8 herunter. CopperSmith CSRB-8 6 Seiten. Remote blower / ventilators

Seite drucken

Part 2

Securing the Blower / Ventilator

Mounting Illustration Option 1

Mounting Illustration Option 2

Vibration

Detail

Mount

*IMPORTANT NOTE: Hanger-type vibration isolators and suspension hardware (e.g., threaded rod, slotted angle

iron, hurricane strap) are not supplied with blower. If the blower is suspended with these items, they will absorb

much of the motor's minor vibrations.

For more information about vibration absorbers, visit the following internet sites:

www.grainger.com (e.g., for W.W. Grainger Item 4C879)

www.vibration-absorbers.com

www.vibrationiso.com

CopperSmith, Remote Blower Installation Instructions (All Models), Revised 09-18-16

Follow all applicable codes when installing this unit.

1. Build and install wood supports to framing structure for blower

mounting.

2. Attach blower directly to wood supports.

The Remote Blower's mounting brackets are designed for flexible

and easy installation at any angle-horizontal, vertical or diagonal.

The brackets should be bolted directly to a 2" x 4" type wood

framing structure (e.g., an attic truss) or suspended by threaded

rod, slotted angle-iron or hurricane strap. The installation should

be sufficient to support the blower's weight.

Follow all applicable codes when installing this unit.

1. Equipment should be hung in position with temporary fixtures

that can be removed after vibration hangers* are installed.

2. Optional vibration hanger may be fastened directly to the

structure or somewhere between the suspended unit. Be sure

not to over tighten the neoprene element. Install hangers.

3. If threaded rod is used, turn nuts on rod assembly clockwise

one complete turn on each hanger. Repeat this procedure

until temporary hangi ng fixtures are loose and blower is

suspended completely on the vibration hangers.

4. Remove temporary fixtures and level ducting and blower by

taking additional turns on the spring / top hanger rod nut as

required.

Page 4