Gallo Tech GStarter I Betriebs- und Installationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Betriebs- und Installationshandbuch für Fernstart Gallo Tech GStarter I herunter. Gallo Tech GStarter I 12 Seiten. Push button start & alarm system with 2 remote key fobs

Seite drucken

1.7 TROUBLESHOOTING

ENGINE CRANKS BUT WILL NOT START:

Check Ignition switch wiring. The

wire should be the RED Start Input +12 v from connector C1 and the C3 PINK wire. Some vehicles

require 2 separate ignition wires for the vehicle's ignition system to function properly. Make sure both of

these ignition wires have not been cut.

ENGINE STARTS IN DRIVE OR REVERSE GEAR (AUTOMATIC TRANSMISSION).

Check the location of ORANGE (Key Start Input) and BLUE (Start Engine Output) wires. They MUST be

connected to the vehicles start wire close to the ignition switch, making certain that the Park/Neutral

lockout is not bypassed.

AN ACCESSORY (RADIO, HEATER FAN, ETC.) DOES NOT TURN OFF DURING ENGINE

CRANKING AND/OR TURN BACK ON AFTER CRANKING:

a.) R1/R2 Relays have not been connected to the correct Ignition switch wires. There are usually only

two positions on the ignition switch which disconnect power to the accessories during engine

cranking. Check the specific wiring diagrams for your Make, Model, and Year vehicle.

b.) Check the RED +12v from R1/R2 relay pair. It must be connected to the BLUE (Start Engine

Output) C1: wire. Also check the BLACK R1/R2 wire making certain that it is connected to a good

chassis ground.

c.) Check the 10 Amp fuse. If it is blown then there must be a short somewhere along the RED R1/R2

wire.

DOORS LOCK/UNLOCK WHEN THEY SHOULD UNLOCK/LOCK:

Connector C2: 6 Pin Wire Harness wires have been incorrectly connected to the vehicles Master Lock

switch. Reverse the wires.

Gallo

wire must not be cut. The only

IGN 1

INSTALLATION NOTES

- 12 -

wires connected to this

52008