Galls Street Thunder ST280 Installations- und Betriebsanleitung - Seite 16
Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Verstärken Galls Street Thunder ST280 herunter. Galls Street Thunder ST280 18 Seiten. Siren amplifier & light controller
Auch für Galls Street Thunder ST280: Installations- und Betriebsanleitung (20 seiten)
Seite drucken
This unit is designed to provide years of reliable service under even the worst
conditions. Many times there may appear to be a problem with the unit when the
true problem is in the speaker(s) or improper installation. The following chart
shows typical symptoms and possible causes.
TROUBLESHOOTING
Symptom
No power
Yellow wire is not powered
Connector loose
Siren 20A fuse blown
Loose connection at power source
No siren tone -
High voltage protection
PA works
Low voltage protection
Microphone button stuck
Park Kill polarity option set wrong
Park Kill activated
No siren tone -
Bad speaker or speaker wiring
No sound
No PA
PA volume not set properly
Distorted siren
Speaker assembly loose
sound
Intermittent Aux. Input connection
Low or high vehicle voltage
Intermittent
High voltage protection
siren tone
Low voltage protection
Microphone button activation
Circuit breaker in supply
connection
Shorted speaker or speaker wire
Horn function
Manual/Horn rocker switch stuck
or
Aux. Input improperly connected
Manual or
Aux. Input Polarity Option set
Thunder stuck
wrong
on
No Radio
Unit not connected to radio
Radio volume too low
No or Low
Radio outputs not isolated and
Radio
polarity
hooked up backwards
Wrong siren
Two-Tone option jumper installed
tone
Aux. Input set to wrong function
Thunder not
Thunder disabled
working
SERVICE
Possible Cause
Is yellow wire connected to switched +12VDC?
Check connector
Is power hooked up backwards? Positive ground vehicle?
Is an external fuse or circuit breaker used?
Are the negative leads connected to a good ground?
The input voltage must be less than 16 volts.
The input must be greater than 10V with the siren turned on.
Does microphone button release properly?
Is the PK jumper option properly configured?
Does the siren work when Park Kill input is disconnected?
Check for a short.
Check for an open.
Have you tried turning the PA volume control?
Is the speaker bell or tip loose?
Is the Aux. Input used and wired properly?
Input voltage must be between 10-16 volts while siren is on.
Is the vehicle voltage regulator working properly?
Is the connector tight on the back of the unit? Is there a loose
connection on a power lead? The input must be greater
than 10V with the siren turned on.
Is something lying on the microphone?
Is a circuit breaker used with at least a 50A rating?
Does the speaker have water damage, or is a wire pinched?
Does the switch return fully when released?
Is the Aux. Input used and wired properly?
Is the AUX jumper option properly configured?
Is the radio connected properly to the unit?
Can you hear the radio in the vehicle?
Have you tried turning the Radio volume control?
Are the radio wires connected to the correct polarity from the
radio output?
Is the TT jumper option properly configured?
Is the AUX jumper option configured properly?
Is the TD jumper option configured properly?
-15-
Check