Galls Street Thunder ST280 Installations- und Betriebsanleitung - Seite 6
Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Verstärken Galls Street Thunder ST280 herunter. Galls Street Thunder ST280 20 Seiten. Siren amplifier & light controller
Auch für Galls Street Thunder ST280: Installations- und Betriebsanleitung (18 seiten)
Seite drucken
SAFETY PRECAUTIONS
For the safety of the installer, vehicle operator, passengers and the community
please observe the following safety precautions. Failure to follow all safety
precautions and instructions may result in property damage, injury or death.
• Mount in a location with adequate ventilation to prevent overheating.
• Devices should be mounted only in locations listed in SAE standard J1849.
• Controls should be placed within convenient reach of the driver.
• Assure clearances before drilling in vehicle.
• Sound levels produced by attached speakers can cause permanent hearing loss.
• Never operate this unit without adequate hearing protection for you and others
in the area. (OSHA 1910.95)
• Consider wire routing and access to connections.
• Install mounting bracket to vehicle using 1/4" hardware (not supplied).
• Drill 1/8" holes and install the microphone bracket to the vehicle using the
two included screws.
Wire Size and Termination
Electrical connections to this unit are made through the green 12-terminal
connector located in the rear of the unit (See below - Part # CPSS-153).
Examine the charts on the following page to determine the proper gauge of the
wire to use. Please review the following recommendations when making your
electrical connections:
• For safety and reliability we highly recommend that you always use both Power
wires (pins 1 & 4) and both Ground wires (2 & 5).
• Use only high quality crimp connectors. Make sure all connections are tight.
• Minimize the number of splices to reduce voltage drop.
• Route wiring to prevent wear, overheating, and interference with air bag
deployment.
• Use grommets and sealant when passing through compartment walls.
• Ground connections should be made directly to the negative of the vehicle
battery. Where not possible, only connect to substantial chassis components.
• Install and check all wiring before connection to vehicle battery.
• CAUTION: All wires should be rated for at least 125% of their maximum current
load. All wires connected to the positive terminal of the battery should be fused
at the battery for their rated load.
• Review the charts on the following page that indicate the recommended wire
gauge, based upon the length of the wire run and the current that will pass
through the wire.
Mounting
Electrical Connections
-4-