CORA CS1030 Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör CORA CS1030 herunter. CORA CS1030 19 Seiten. Wall receptacle outlet

Installation

If you are not comfortable working with 120V electrical wiring, please consult or hire

a qualified electrician. Turn off circuit(s) at the breaker or fuse panel and confirm

there is no voltage in the box before starting the installation (there may be multiple live circuits

within the switch box). Failure to use best electrical safety practices can result in injury or death!

All wiring connections must be made after the power is turned off to avoid personal injury and/or

damage to the outlet.



In-wall Outlet is designed and intended for indoor use only!



Total 15-amp maximum current. (Refer to the equipment or light bulb/fixture specifications if

in doubt).



Outlet is designed and intended only for permanently installed fixtures, and in accordance

with the national and local electrical codes and regulations of the United States or Canada,

as applicable

Please ensure that the following equipment and electrical requirements are met before installing

the outlet.



Existing wall outlet replacement or new box with wiring ready has three wires: line (black),

neutral (white), ground (green).



At least two (2) inches of box depth is required (2 1/8" deep electrical boxes are typical).

Tools: you will need a Phillips screwdriver, flat-head screwdriver, wire strippers, and



voltage tester.



Turn off Circuit(s) at the breaker or fuse panel and confirm there is no

voltage in the electrical box before starting installation (there may be

multiple live circuits within the switch box).



Unscrew and remove the outlet plate; then use a voltage tester to

confirm the circuit is dead

CS1030 Long Range Wall Receptacle Outlet – User Guide

Page 8