CORA CS1040 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör CORA CS1040 herunter. CORA CS1040 20 Seiten. Long range tilt & vibration sensor

CS1010 Long Range Vibration Sensor – User Guide

Registering the Device

This step requires a third-party mobile application, which can register new devices. Please

follow the application instructions for registration and activation. Cora devices are typically

registered by scanning the QR code printed on the device housing or attached label.

Once the device is removed from the packaging, it can be activated by pressing the set button.

The device will activate, blinking orange four times and begin issuing join requests. The LED

status indicators is shown in the figure below.

Figure 2 – CS1040 LED Status Indicators

Periodically, the CS1040 will blink red twice when joining the network. Assuming the device is

properly registered on an available network and in range, it should connect. It will blink green

four times indicating it has joined.

Once joined, the vibration sensor can be tested by placing the device in a wet dish or touching

the top sensors with a wet finger. By default, the unit will generate vibration detected events to

notify the application. Reminders and other configurations options are available.

Note: If the CS1040 has not joined within a few minutes, the LED will stop blinking, though it will

continue try to join: ten times in the first hour, then longer intervals over the first week until finally

attempting once every 12 hours. This is done to conserve battery power when the network is not

available for long periods of time. You may reset the join schedule by performing a Network

Reset on the device, see User Interface.

To learn more about the capabilities of the CS1040, see Configuration and Integration.

Page 4