Galmet SG Fusion 100 Installations- und Betriebshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Kesselbedarf Galmet SG Fusion 100 herunter. Galmet SG Fusion 100 12 Seiten. Layered tank for dual function gas boilers

Seite drucken

5. Titanium, maintenance-free, active anode

5.1. Pros of the titanium anode

- reliable, durable protection
- low consumption of anodes
- no sludge on the anode
- not required regeneration
- guaranteed long-term operation of the tank
NOTE ! Before installing the anode CORREX, remove existing protective magnesium anode.
1. Cable supplied bipolar, connecting the anode CORREX and potentiometer plug must not be lengthened.
2. A random change in polarity causes the acceleration of corrosion.
3. It is recommended to use the socket 230 V in a short distance from the tank.

5.2. Troubleshooting

LED CONTROL
CAUSE
- Anode CORREX working properly. Full protection against corrosion.
ON - green colour
- Lack of electricity.
OFF
- Lack of water in the tank.
ON - red colour
- Cables between the electronic part and the anode is connected incorrectly.
- Lack of contact between the ground (tank) and the electrical part of the anode.
- The anode is contacted with the mass of the tank.
It is NECESSARY to use a dielectric connectors (made out of a plastic material - electrically nonconductive) between the hot and cold water
connections and the installation's connections in order to avoid iron-copper contact, also in case where the relief group is connected directly
to the tank. This extends the life of the water tank and prevents electrolysis phenomena, especially when the water is acidic (pH <7).
The symbol presented beside signifies that it is prohibited to dispose of worn electrical and electronic devices together with other waste.
These products should be delivered to assigned waste collection points for waste processing. A proper recycling of electrical and electronic
devices helps to protect the natural environment and prevents negative impact on human health.
6. Product fiche (according to EU Regulation No 812/2013)
6.1. SG(S) Fusion
1
EN - Supplier's name or trade mark
2
EN - Supplier's model identifier
3
EN - Energy efficiency class
4
EN - Standing loss [W]
5
EN - Storage volume [L]
© All rights reserved - Galmet Sp. z o.o. Sp. K.
5. Titanium anode CORREX / 6. Product fiche
1. Titanium anode
2. Potentiometer (AC)
3. Grounded cord
METHOD OF REMOVAL
-
- Check the voltage 230 V.
- Fill the tank with water.
- Put the cables at the anode.
- Check and clean the rust all connections.
- Properly isolate the anode from the tank.
Galmet
SG(S) Fusion 100
C
61
104
Installation and Operating Manual - SG(S) Fusion
7