Dynex DX-LM100 - Wireless Laser Mouse Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Maus Dynex DX-LM100 - Wireless Laser Mouse herunter. Dynex DX-LM100 - Wireless Laser Mouse 12 Seiten. Wireless laser mouse

Seite drucken

1. Setting up the Wireless Mouse

Using the wireless mouse

Controlling the mouse

This laser mouse has a high resolution of 1600 dpi, which provides the

most reliable and accurate movement.

• Avoid using the mouse on any reflective, transparent, metallic, or

complex-pattern surfaces such as glass or a mirror.

• Avoid using the mouse under the following conditions:

• Direct sunlight

• Extreme hot, cold, dusty, or magnetic environment

• Near a fax machine, television, radio, mobile phone or any

wireless device

• Press any button to wake up the keyboard or the mouse while the

mouse is in sleeping mode.

• Scroll the wheel to wake up the mouse while the mouse is in the

sleeping mode.

Using power-saving

The optical sensor can be turned off to save power.

To use power-saving:

1 Press and hold middle of the scroll wheel, then press the

Connect/Link button on the bottom of the mouse. The optical

sensor turns off.

2 To turn the sensor back on again, perform the same actions.

Using mouse power management

To use mouse power management

1 Right-click the mouse icon in the windows taskbar, then click

Active Mouse Properties.

2 Click the Hardware tab, then double-click USB Browser Mouse

Device.

3 Click the Power Management tab, then check the box for Allow

this device to bring the computer out of standby.

4 Click OK.

Charging the mouse

The mouse scroll wheel will light when the mouse batteries are low.

Change or recharge the batteries immediately. Do not use the mouse

during while it is charging.

To charge the mouse:

1 Connect the cord of the receiver cradle to the AC/DC adapter, then

connect the AC/DC adapter to the power outlet.

2 Place the mouse in the cradle and allow the mouse to charge.

A solid red LED means that the mouse is charging, and a blinking

red LED means that the mouse is fully charged.

Troubleshooting

If the mouse is malfunctioning, do one of the following:

• Change or recharge the batteries.

• Move the receiver away from the computer and the monitor and

repeat the set-up procedure on page 2.

• Make sure the USB port on the computer is working.

• Make sure that the receiver connector or cable is not broken or

tangled.

Legal notices

Radio and TV Interference Statement

This equipment has been tested and found to comply within the limits

for a Class B digital device, pursuant to Part 15 of the FCC rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and if not installed and used in

accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference

will not occur in a particular installation.

This Class B digital apparatus complies with Canadian ICES-003.

Enterprise Services, Inc. Other brands and product names are trademarks

or registered trademarks of their respective holders. Specifications and

features are subject to change without notice or obligation.

Using the wireless mouse