Galvin Engineering Haws SP220SS Produkt-Installations-Manualline - Seite 6

Blättern Sie online oder laden Sie pdf Produkt-Installations-Manualline für Sanitärprodukt Galvin Engineering Haws SP220SS herunter. Galvin Engineering Haws SP220SS 7 Seiten. Pedestal floor mtd, axion msr eye/face wash head, s/s bowl, hand & foot act
Auch für Galvin Engineering Haws SP220SS: Produkt-Installations-Manualline (7 seiten)

Seite drucken

TROUBLESHOOTING

PROBLEM

1. No Flow.

2. Insufficient water flow.

3. Insufficient water flow on eye/face

wash, however, shower is sufficient

4. Eye/face wash streams do not meet

desired eye level.

5. Water does not drain properly.

6. Water leak between joints or fittings.

7. Insufficient water flow from shower,

however, eye/face wash is sufficient.

For more information about GalvinSafe

Check the main shut-off valve.

Verify minimum 210 kPa flowing supply

line pressure.

3. a. Verify minimum 210 kPa flowing supply

b. Probable clogging of flow control due

to inadequate line flushing. Unscrew

eye/face wash head and remove the

four screws to disassemble head.

Clean flow control and reassemble

Head.

c. Remove plug located on L – Strainer

using a 9/16" wrench to access

4. Possible blocked flow control, see above

solution. Possible non-leveled eye/face

wash assembly

5. Check your drain system for debris. Check

the main waste line of your building to see

if it does handle the capacity required for

the entire drainage system

6. Tighten loose connections. If leak persists,

the application of hot water will sometimes

reseat improperly applied joint compound.

After 30 minutes wait and retest. A

persistent leak will necessitate reassembly

and additional sealant.

7. Probable clogging of flow control inside

showerhead. Unscrew showerhead off of

elbow and clean rubber flow control.

(Haws) products, see our website.

Version 3.1, 13

REPAIR CHECKLIST

line pressure

clean filter screen.

Aug. 2021, Page 6 of 7