Dynex DX-TVM111 Montageanleitung - Seite 6
Blättern Sie online oder laden Sie pdf Montageanleitung für TV-Halterung Dynex DX-TVM111 herunter. Dynex DX-TVM111 13 Seiten. Quick setup guide (french)
Auch für Dynex DX-TVM111: Handbuch zur Schnelleinrichtung (2 seiten), (Englisch) Kurzanleitung zur Konfiguration (2 seiten), (Französisch) Guide D'installation Rapide (2 seiten)
Seite drucken
6
DX-TVM111
STEP 2 - Option 2: Installing on a solid concrete* or concrete block wall
CAUTION:
directly onto the concrete surface.
1 Align the wall plate template (J) at the height you determined in the previous step and make sure that it is
level. Tape the wall plate template in position, then use a pencil to mark the lag bolt hole locations (2).
Remove the wall plate template.
2 Drill pilot holes to a depth of 2.5 in. (63.5 mm) using a 7/16 in. (11 mm) diameter masonry drill bit.
3 Insert the concrete wall anchors (H) into the pilot holes and use a hammer to make sure the anchors are flush
with the concrete surface.
4 Align the wall plate (B) with the anchors, insert the lag bolts (G) through the holes in the wall plate, then
tighten the lag bolts only until they are firm against the wall plate.
CAUTION:
DO NOT over-tighten the lag bolts (G).
* Minimum solid concrete thickness: 8 in. (203 mm)
* Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm)
You'll need
G (2)
H (2)
Wall plate (B)
To prevent property damage or personal injury, never drill into mortar between blocks. Mount wall plate
Avoid potential injuries or property damage!
J
Level
Hammer
B
G
DX-TVM111
Template • Gabarit • Plantilla
Top
Haut
Parte superior
Tools Needed
Outils nécessaires
Herramientas requeridas
Note
Remarque : Pour une construction à ossature de bois,
localiser d'abord les montants en bois, à l'aide d'un
détecteur de montants.
Nota: para la instalación en construcciones de armazón de
madera, primero debe localizar las vigas de madera con un
localizador de vigas.
Pencil
Need more information about your mount? Scan
this QR code or visit www.dynexproducts.com.
<FR>Need more information about your mount?
Scan this QR code or visit www.dynexproducts.com.
<SP>Need more information about your mount?
Scan this QR code or visit www.dynexproducts.com.
http://san.us/284
V1 13-0138
Drill
Template (J)
Tape
Installation instructions
H
7/16"
masonry drill
7/16" socket
bit
wrench
2.5 in.
(63.5 mm)