Maijie TIWB1610LS2 Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Interaktives Whiteboard Maijie TIWB1610LS2 herunter. Maijie TIWB1610LS2 12 Seiten. Aircraft design smart whiteboard
Seite drucken3.3 Knob Control Panel operation steps
3.31 Boot and shutdown
Boot: Place the IC card in the swiping area (see the figure below) for 2-3 seconds
or long time, the power indicator on the panel flashes and then disappears (see the
figure below), with the "system startup" sound, it means the boot is successful.
Shutdown: Press and hold the knob button (see the figure below) for more than 3
seconds, until you hear the sound "shutdown", and the power indicator on the panel
lights up, it means the shutdown is successful.
1. Swiping area
3.32 Turn signal switch
Turn the knob button to the right to get wireless projection among local computer,
notebook and Visual presenter.
3.33 Volume adjustment control
Turn the volume adjustment knob to the left to decrease the sound, turn to the right
to increase the sound, and tap the knob to mute.
4. Troubleshooting
The
microphone
1
has no sound
No power
2
No video
3
output
PAGE 07
2. Power indicator light
Make sure the microphone power has
turned on
Did you press the transmitter mute
button?
The frequency is not successful (the red/
green lights flash alternately)
Is the power cord plugged in?
Is the socket fuse blown?
Is the projector HDMI cable connected
properly?
Pressed the lock button
Does the signal source connect to input
device normally?
3. Knob button
Turn on the microphone power
Press the transmitter mute button
again
Close to the All In One Teaching System,
turn on the transmitter power again
Check the power cord
Check power cord connection to see if
you need to change a fuse
Check HDMI cable connection
Pressed the lock button again
Turn on the PC and switch to the PC
source