Galvo Shed GVO 3030 Montageanleitung Handbuch - Seite 6
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Lagerung im Freien Galvo Shed GVO 3030 herunter. Galvo Shed GVO 3030 8 Seiten. Gable roof shed
Seite drucken
STEP 6
END WALLS
Join 3
sheets together to create a gable end wall as shown. Make a cut in the
E
centre (1145mm) of the 2290mm top channel
the bottom of the sheets with an
now. Slip
gable plate under channel at the top and rivet to sheeting at the *.
R
Rivet the channels at every 2nd rib and thru gable plate into sheeting ribs.
Place 3 rivets up underneath through channel into pan of sheet.
Perform the same again for the other end.
STEP 7
DOOR BRACES
The door braces can be fitted now or after you have assembled your shed.
Tuck one end of the 'Z' between the bottom channel of the inside of the
door and the sheet. Do the same at the top, overlapping in the centre
behind the padbolt.
If you have a locking 'T' handle you will have to run the 'Z's the opposite
way to the diagram.
Rivet the 'Z's at the ends, and in the centre of the channel it is tucked
under, and through the overlap in the centre. Two or three more fixings will
be required through the door sheeting into the 'Z', but they will need to be
riveted through from the outside of the door for a neater appearance.
You may need to cut or bend the flange at the bottom and the top of the
'Z' if it catches on the door jamb when opening or closing (diagram 1).
DIAGRAM 1
BEFORE
6
and cap the three
I
2255mm channel. Rivet at corners only for
H
H
CHANNELS
Channels will end 15-20mm
short at tops of end walls
and 10-15mm at bottoms.
5
sheets. Cap
E
E
AFTER
If you choose to vary from these instructions your warranty will be impaired
YOU WILL NEED
E
4 x 1960mm angle cut sheets & 2 x
2025mm gable cut sheets (end walls)
2 x 2255mm 'U' channels (bottom)
H
2 x 2290mm 'U' channels (top)
I
R
2 x gable plates
I
YOU WILL NEED
O
2 x 'Z' Door braces
N
Fixings
Z door braces in position on
the inside of door sheet
R
ABOVE