Coram TUBULAR SHOWER PANELS Schnellstart-Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Armaturen für das Badezimmer Coram TUBULAR SHOWER PANELS herunter. Coram TUBULAR SHOWER PANELS 9 Seiten.

Seite drucken
Struts
PN10658
Wall channel
PN10640
Wall channel
PN10640
4
Options:
a
For Horizontal
strut installation
follow steps:
4 - 16
For Vertical
strut installation
follow steps:
17 - 25
a: Ensure that the opening end of the panel is vertical and the panel is parallel with the opposite wall. Carefully
measure the distance 'X' between the glass panel and the wall.
b: If required, trim the strut to length: X + 50mm. c: Push-fit the end cap onto the untrimmed end of the strut.
1
Max.
opening
800mm
ONLY Horizontal strut
installation
Plan position of panels. Place the first wall channel in position against the wall at the required
distance from the opposite wall, as shown (Horizontal strut installation - maximum of 980mm).
a: Ensure the wall channel is vertical and mark the four holes onto the wall.
b: Drill the four positions marked using a 6mm drill bit.
c: Apply silicone sealant to the back of the wall channels
d: Insert the wall plugs. Place washers over the 32mm screws and fix the wall channel to the
wall. If necessary, slight adjustment is available in the wall channel.
Horizontal strut installation
X
Opening
Wall
=
=
DOUBLE PANEL
c
a
b
ø 6
mm
d
32
mm
980mm max. -
ONLY Horizontal
strut installation
b
X + 50mm
c
Untrimmed
end of strut
2
Slide both seals down into the wall channel and
cut off any excess.
Note the orientation of the soft flippers.
5
Approx.
100mm
Assemble the strut: slide on the panel bracket and wall bracket assembly. Lightly tighten the fitted
grub screws. Carefully place the strut assembly onto the glass, approximately 100mm from the edge
(depending on your installation). Ensure the strut is level and mark the position of the wall bracket
assembly onto the wall.
3
IMPORTANT
Ensure Glass Guard H2o
label is to the outside of
the enclosure/panel
Satin glass patterns must
be installed to the outside
of the enclosure.
Note:
The Glass Guard coating is
on the opposite side to the
label or satin glass patterns
Carefully push the panel into the wall channel.
Note: Wetting the edge of the panel with water will
help the panel insert.
PN80456
PAGE 5