HIKE CREW HCSSCRNG4 Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Outdoor-Einrichtung HIKE CREW HCSSCRNG4 herunter. HIKE CREW HCSSCRNG4 7 Seiten.
Seite druckenASSEMBLY INSTRUCTIONS
Gazebo Setup
1. Locate a level, flat surface that is clear of debris to prevent rips or cuts while setting up your tent.
2. Lay the tent flat on the cleared-out area. Then, check that there is no material twisting or overlapping.
PLEASE READ THE INSTRUCTIONS CAREFULLY
SET-UP STEPS
3. Grasp the webbing loop sewn into the center of the top panel and pull the loop outward.
1.Spread the flysheet out on the ground, as flat as possible
2. Fold up each of the poles, then lift the top panel up, whilst pulling each side panel out by the
4. Continue around the tent pulling the loops on the side wall panels outward. Pull until side wall
corresponding metal pulling loop on either side, then the integral fibreglass poles will simply pop
panels are popped out. (The fiberglass poles should pop out into place holding up the gazebo.)
into place.
These pictures can be instead by the physical photo if need
5. With the gazebo now freestanding, locate the zippered door, and walk into the tent.
3.Peg down the four corners of the flysheet to make it stable
6. Once inside the gazebo, place a hand on the top panel and push up until roof pops into place.
TAKE-DOWN STEPS
7. Move outside and anchor your gazebo down at each corner by tying the ropes down to the pegs
Push the side metal pulling loop into make the flysheet down ,then push the top panel in, at last
(or stakes) provided.
fold it along with the pole
8. Place pegs firmly into the ground and hammer down the peg to keep gazebo stable.
CHECK FOR PARTS ONLINE AT WWW.........
OR CALL 000-000-0000
PLEASE READ THE INSTRUCTIONS CAREFULLY
PLEASE READ THE INSTRUCTIONS CAREFULLY
SET-UP STEPS
1.Spread the flysheet out on the ground, as flat as possible
SET-UP STEPS
1.Spread the flysheet out on the ground, as flat as possible
2. Fold up each of the poles, then lift the top panel up, whilst pulling each side panel out by
corresponding metal pulling loop on either side, then the integral fibreglass poles will simply
2. Fold up each of the poles, then lift the top panel up, whilst pulling each side panel out by
into place.
corresponding metal pulling loop on either side, then the integral fibreglass poles will simply
These pictures can be instead by the physical photo if need
into place.
These pictures can be instead by the physical photo if need
3.Peg down the four corners of the flysheet to make it stable
PLEASE READ THE INSTRUCTIONS CAREFULLY
3.Peg down the four corners of the flysheet to make it stable
SET-UP STEPS
1.Spread the flysheet out on the ground, as flat as possible
TAKE-DOWN STEPS
Push the side metal pulling loop into make the flysheet down ,then push the top panel in, at
2. Fold up each of the poles, then lift the top panel up, whilst pulling each side panel out by
TAKE-DOWN STEPS
fold it along with the pole
corresponding metal pulling loop on either side, then the integral fibreglass poles will simpl
Push the side metal pulling loop into make the flysheet down ,then push the top panel in, at
into place.
fold it along with the pole
These pictures can be instead by the physical photo if need
CHECK FOR PARTS ONLINE AT WWW.........
3.Peg down the four corners of the flysheet to make it stable
OR CALL 000-000-0000
CHECK FOR PARTS ONLINE AT WWW.........
OR CALL 000-000-0000
TAKE-DOWN STEPS
Push the side metal pulling loop into make the flysheet down ,then push the top panel in, a
fold it along with the pole
3